Datasheet

PIC12(L)F1501
DS40001615C-page 216  2011-2015 Microchip Technology Inc.
TABLE 27-3: POWER-DOWN CURRENTS (IPD)
(1,2)
PIC12LF1501
Operating Conditions: (unless otherwise stated)
Low-Power Sleep Mode
PIC12F1501
Low-Power Sleep Mode, VREGPM = 1
Param.
No.
Device Characteristics Min. Typ†
Max.
+85°C
Max.
+125°C
Units
Conditions
V
DD Note
D022 Base I
PD — 0.020 1.0 8.0 A 1.8 WDT, BOR, FVR and SOSC
disabled, all Peripherals inactive
— 0.03 2.0 9.0 A3.0
D022 Base IPD — 0.25 3.0 10 A 2.3 WDT, BOR, FVR and SOSC
disabled, all Peripherals inactive,
Low-Power Sleep mode
— 0.30 4.0 12 A 3.0
— 0.40 6.0 15 A 5.0
D022A Base IPD — 10 16 18 A 2.3 WDT, BOR, FVR and SOSC
disabled, all Peripherals inactive,
Normal Power Sleep mode,
VREGPM = 0
— 11 18 20 A 3.0
— 12 21 26 A 5.0
D023 — 0.26 2.0 9.0 A 1.8 WDT Current
— 0.44 3.0 10 A3.0
D023 — 0.43 6.0 15 A 2.3 WDT Current
— 0.53 7.0 20 A 3.0
— 0.64 8.0 22 A 5.0
D023A — 15 28 30 A 1.8 FVR Current
—18 30 33 A3.0
D023A — 18 33 35 A 2.3 FVR Current
— 19 35 37 A 3.0
— 20 37 39 A 5.0
D024 — 6.0 17 20 A 3.0 BOR Current
D024 — 7.0 17 30 A 3.0 BOR Current
— 8.0 20 40 A 5.0
D24A — 0.1 4.0 10 A 3.0 LPBOR Current
D24A — 0.35 5.0 14 A 3.0 LPBOR Current
— 0.45 8.0 17 A 5.0
* These parameters are characterized but not tested.
† Data in “Typ” column is at 3.0V, 25°C unless otherwise stated. These parameters are for design guidance only and are
not tested.
Note 1: The peripheral  current can be determined by subtracting the base I
PD current from this limit. Max. values should be
used when calculating total current consumption.
2: The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is measured with
the part in Sleep mode, with all I/O pins in high-impedance state and tied to V
SS.
3: ADC clock source is FRC.