MCP6L01/1R/1U/2/4 1 MHz, 85 µA Op Amps Features: Description: • • • • • • • The Microchip Technology Inc. MCP6L01/1R/1U/2/4 family of operational amplifiers (op amps) supports general purpose applications. The combination of railto-rail input and output, low quiescent current and bandwidth fit into many applications. Available in SC-70-5 and SOT-23-5 Packages Gain Bandwidth Product: 1 MHz (typical) Rail-to-Rail Input/Output Supply Voltage: 1.8V to 6.
MCP6L01/1R/1U/2/4 NOTES: DS22140B-page 2 2009-2011 Microchip Technology Inc.
MCP6L01/1R/1U/2/4 1.0 1.1 ELECTRICAL CHARACTERISTICS † Notice: Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress rating only and functional operation of the device at those or any other conditions above those indicated in the operational listings of this specification is not implied. Exposure to maximum rating conditions for extended periods may affect device reliability. Absolute Maximum Ratings † VDD – VSS ...........................
MCP6L01/1R/1U/2/4 TABLE 1-2: AC ELECTRICAL SPECIFICATIONS Electrical Characteristics: Unless otherwise indicated, TA = 25°C, VDD = +5.0V, VSS = GND, VCM = VSS, VOUT VDD/2, VL = VDD/2, RL = 10 k to VL and CL = 60 pF (refer to Figure 1-1). Parameters Sym Min Typ Max Units Conditions AC Response Gain Bandwidth Product GBWP — 1.0 — MHz Phase Margin PM — 90 — ° Slew Rate SR — 0.
MCP6L01/1R/1U/2/4 2.0 TYPICAL PERFORMANCE CURVES Note: The graphs and tables provided following this note are a statistical summary based on a limited number of samples and are provided for informational purposes only. The performance characteristics listed herein are not tested or guaranteed. In some graphs or tables, the data presented may be outside the specified operating range (e.g., outside specified power supply range) and therefore outside the warranted range.
MCP6L01/1R/1U/2/4 Note: Unless otherwise indicated, TA = +25°C, VDD = +5.0V, VSS = GND, VCM = VSS, VOUT = VDD/2, VL = VDD/2, RL = 10 kto VL and CL = 60 pF. Input Current Magnitude (A) Input, Output Voltages (V) 6 10m 1.E-02 1m 1.E-03 100µ 1.E-04 10µ 1.E-05 1µ 1.E-06 100n 1.E-07 10n 1.E-08 1n 1.E-09 100p 1.E-10 10p 1.E-11 1p 1.E-12 +125°C +85°C +25°C -40°C -1.0 -0.9 -0.8 -0.7 -0.6 -0.5 -0.4 -0.3 -0.2 -0.1 0.
MCP6L01/1R/1U/2/4 Note: Unless otherwise indicated, TA = +25°C, VDD = +5.0V, VSS = GND, VCM = VSS, VOUT = VDD/2, VL = VDD/2, 50 45 40 35 30 25 20 15 10 5 0 100µ 1.E-04 VDD – VOH IOUT Slew Rate (V/µs) Ratio of Output Headroom to Output Current (mV/mA) RL = 10 kto VL and CL = 60 pF. VOL – VSS -IOUT 1m 1.E-03 Output Current Magnitude (A) P-P ) 0.04 0.02 0.00 -0.02 -0.04 -0.06 -0.08 0.E+00 1.E-06 2.E-06 3.E-06 4.E-06 5.E-06 6.E-06 7.E-06 8.E-06 9.E-06 1.
MCP6L01/1R/1U/2/4 NOTES: DS22140B-page 8 2009-2011 Microchip Technology Inc.
MCP6L01/1R/1U/2/4 3.0 PIN DESCRIPTIONS Descriptions of the pins are listed in Table 3-1. TABLE 3-1: PIN FUNCTION TABLE MCP6L01 MCP6L01R MCP6L01U MCP6L02 MCP6L04 SC-70-5, SOT-23-5 SOT-23-5 SOT-23-5 SOIC-8, MSOP-8 SOIC-14, TSSOP-14 1 4 3 5 — — — — — — 2 — — — — 1 4 3 2 — — — — — — 5 — — — — 4 3 1 5 — — — — — — 2 — — — — 1 2 3 8 5 6 7 — — — 4 — — — — 1 2 3 4 5 6 7 8 9 10 11 12 13 14 — 3.1 Analog Outputs The analog output pins (VOUT) are low-impedance voltage sources. 3.
MCP6L01/1R/1U/2/4 NOTES: DS22140B-page 10 2009-2011 Microchip Technology Inc.
MCP6L01/1R/1U/2/4 4.0 APPLICATION INFORMATION The MCP6L01/1R/1U/2/4 family of op amps is manufactured using Microchip’s state of the art CMOS process. It is designed for low cost, low power and general purpose applications. The low supply voltage, low quiescent current and wide bandwidth makes the MCP6L01/1R/1U/2/4 ideal for battery-powered applications. This device has high phase margin, which makes it stable for larger capacitive load applications. 4.1 Rail-to-Rail Inputs 4.1.
MCP6L01/1R/1U/2/4 4.4 Supply Bypass With this family of operational amplifiers, the power supply pin (VDD for single supply) should have a local bypass capacitor (i.e., 0.01 µF to 0.1 µF) within 2 mm for good high-frequency performance. It also needs a bulk capacitor (i.e., 1 µF or larger) within 100 mm to provide large, slow currents. This bulk capacitor can be shared with other nearby analog parts. 4.5 Unused Op Amps FIGURE 4-4: Layout. 1. An unused op amp in a quad package (e.g.
MCP6L01/1R/1U/2/4 5.0 DESIGN AIDS Microchip provides the basic design aids needed for the MCP6L01/1R/1U/2/4 family of op amps. 5.1 SPICE Macro Model The latest SPICE macro model for the MCP6L01/1R/ 1U/2/4 op amp is available on the Microchip web site at www.microchip.com. The model was written and tested in official Orcad (Cadence) owned PSPICE. For other simulators, translation may be required. The model covers a wide aspect of the op amp's electrical specifications.
MCP6L01/1R/1U/2/4 NOTES: DS22140B-page 14 2009-2011 Microchip Technology Inc.
MCP6L01/1R/1U/2/4 6.0 PACKAGING INFORMATION 6.1 Package Marking Information 5-Lead SC-70 (MCP6L01) Example: Device XXNN MCP6L01 Code BK25 BKNN Note: Applies to 5-Lead SC-70. Example: 5-Lead SOT-23 (MCP6L01/1R/1U) 4 5 Device XXNN 1 2 3 Code MCP6L01 VXNN MCP6L01R VYNN MCP6L01U VZNN Note: Applies to 5-Lead SOT-23.
MCP6L01/1R/1U/2/4 Package Marking Information 14-Lead SOIC (150 mil) (MCP6L04) Example: MCP6L04 e3 E/SL^^ 1134256 XXXXXXXXXX XXXXXXXXXX YYWWNNN 14-Lead TSSOP (MCP6L04) Example: XXXXXX YYWW 6L04STE 1134 NNN 256 DS22140B-page 16 2009-2011 Microchip Technology Inc.
MCP6L01/1R/1U/2/4 .
MCP6L01/1R/1U/2/4 . # # $ # / ! - 0 # 1 / % # # ! # ## +22--- 2 / DS22140B-page 18 2009-2011 Microchip Technology Inc.
MCP6L01/1R/1U/2/4 ! .
MCP6L01/1R/1U/2/4 Note: For the most current package drawings, please see the Microchip Packaging Specification located at http://www.microchip.com/packaging DS22140B-page 20 2009-2011 Microchip Technology Inc.
MCP6L01/1R/1U/2/4 " # $ % # # .
MCP6L01/1R/1U/2/4 Note: For the most current package drawings, please see the Microchip Packaging Specification located at http://www.microchip.com/packaging DS22140B-page 22 2009-2011 Microchip Technology Inc.
MCP6L01/1R/1U/2/4 Note: For the most current package drawings, please see the Microchip Packaging Specification located at http://www.microchip.com/packaging 2009-2011 Microchip Technology Inc.
MCP6L01/1R/1U/2/4 Note: For the most current package drawings, please see the Microchip Packaging Specification located at http://www.microchip.com/packaging DS22140B-page 24 2009-2011 Microchip Technology Inc.
MCP6L01/1R/1U/2/4 " & '( !)* + , - . # # $ # / ! - 0 # 1 / % # # ! # ## +22--- 2 / 2009-2011 Microchip Technology Inc.
MCP6L01/1R/1U/2/4 Note: For the most current package drawings, please see the Microchip Packaging Specification located at http://www.microchip.com/packaging DS22140B-page 26 2009-2011 Microchip Technology Inc.
MCP6L01/1R/1U/2/4 Note: For the most current package drawings, please see the Microchip Packaging Specification located at http://www.microchip.com/packaging 2009-2011 Microchip Technology Inc.
MCP6L01/1R/1U/2/4 . # # $ # / ! - 0 # 1 / % # # ! # ## +22--- 2 / DS22140B-page 28 2009-2011 Microchip Technology Inc.
MCP6L01/1R/1U/2/4 Note: For the most current package drawings, please see the Microchip Packaging Specification located at http://www.microchip.com/packaging 2009-2011 Microchip Technology Inc.
MCP6L01/1R/1U/2/4 Note: For the most current package drawings, please see the Microchip Packaging Specification located at http://www.microchip.com/packaging DS22140B-page 30 2009-2011 Microchip Technology Inc.
MCP6L01/1R/1U/2/4 Note: For the most current package drawings, please see the Microchip Packaging Specification located at http://www.microchip.com/packaging 2009-2011 Microchip Technology Inc.
MCP6L01/1R/1U/2/4 NOTES: DS22140B-page 32 2009-2011 Microchip Technology Inc.
MCP6L01/1R/1U/2/4 APPENDIX A: REVISION HISTORY Revision B (September 2011) The following is the list of modifications: 1. 2. Updated the value for the Current at Output and Supply Pins parameter in the 1.1 “Absolute Maximum Ratings †”section. Added Section 5.1 “SPICE Macro Model”. Revision A (March 2009) • Original Release of this Document. 2009-2011 Microchip Technology Inc.
MCP6L01/1R/1U/2/4 NOTES: DS22140B-page 34 2009-2011 Microchip Technology Inc.
MCP6L01/1R/1U/2/4 PRODUCT IDENTIFICATION SYSTEM To order or obtain information, e.g., on pricing or delivery, refer to the factory or the listed sales office. PART NO.
MCP6L01/1R/1U/2/4 NOTES: DS22140B-page 36 2009-2011 Microchip Technology Inc.
Note the following details of the code protection feature on Microchip devices: • Microchip products meet the specification contained in their particular Microchip Data Sheet. • Microchip believes that its family of products is one of the most secure families of its kind on the market today, when used in the intended manner and under normal conditions. • There are dishonest and possibly illegal methods used to breach the code protection feature.
Worldwide Sales and Service AMERICAS ASIA/PACIFIC ASIA/PACIFIC EUROPE Corporate Office 2355 West Chandler Blvd. Chandler, AZ 85224-6199 Tel: 480-792-7200 Fax: 480-792-7277 Technical Support: http://www.microchip.com/ support Web Address: www.microchip.