Datasheet

MCP6001/1R/1U/2/4
DS21733H-page 8 © 2008 Microchip Technology Inc.
3.0 PIN DESCRIPTIONS
Descriptions of the pins are listed in Table 3-1.
TABLE 3-1: PIN FUNCTION TABLE
3.1 Analog Outputs
The output pins are low-impedance voltage sources.
3.2 Analog Inputs
The non-inverting and inverting inputs are high-
impedance CMOS inputs with low bias currents.
3.3 Power Supply Pins
The positive power supply (V
DD
) is 1.8V to 6.0V higher
than the negative power supply (V
SS
). For normal
operation, the other pins are at voltages between V
SS
and V
DD
.
Typically, these parts are used in a single (positive)
supply configuration. In this case, V
SS
is connected to
ground and V
DD
is connected to the supply. V
DD
will
need bypass capacitors.
MCP6001 MCP6001R MCP6001U MCP6002 MCP6004
Symbol Description
SC-70-5,
SOT-23-5
SOT-23-5 SOT-23-5
MSOP,
PDIP, SOIC
PDIP, SOIC,
TSSOP
1141 1V
OUT
, V
OUTA
Analog Output (op amp A)
4432 2V
IN
–, V
INA
– Inverting Input (op amp A)
3313 3V
IN
+, V
INA
+ Non-inverting Input (op amp A)
5258 4V
DD
Positive Power Supply
——— 5 5V
INB
+ Non-inverting Input (op amp B)
——— 6 6
V
INB
–
Inverting Input (op amp B)
——— 7 7V
OUTB
Analog Output (op amp B)
———— 8V
OUTC
Analog Output (op amp C)
———— 9V
INC
– Inverting Input (op amp C)
———— 10V
INC
+ Non-inverting Input (op amp C)
252411V
SS
Negative Power Supply
———— 12V
IND
+ Non-inverting Input (op amp D)
———— 13V
IND
– Inverting Input (op amp D)
———— 14V
OUTD
Analog Output (op amp D)