Datasheet
2003-2019 Microchip Technology Inc. DS20001801J-page 89
MCP2515
APPENDIX A: REVISION HISTORY
Revision J (January 2019)
The following is the list of modifications:
1. Added Exposed Thermal Pad description to
Table 1-1.
2. Updated Section 8.1 “Oscillator Start-up
Timer”.
3. Updated Register 10-1.
4. Updated Table 11-2.
5. Updated Table 13-1 in Section 13.0 “Electrical
Characteristics”.
6. Updated the Product Identification System
section.
Revision H (November 2016)
The following is the list of modifications:
1. Updated the voltage range, which was widened
to 2.7V to 5.5V for the E temperature device.
There are two parameters that differ between
the I and E temperature devices: I
DDS
and F
OSC
(T
OSC
).
2. Specified that the usage of the RXM[1:0] bit set-
tings, ‘01’ and ‘10’ in the RXBnCTRL registers is
not recommended.
Revision G (August 2012)
The following is the list of modifications:
1. Updated content in Register 4-1, Register 4-12,
Register 4-13, Register 4-16, Register 4-17.
Revision F (October 2010)
The following is the list of modifications:
1. Added 20-lead QFN package (4x4) and related
information.
2. Updated Table 1-1.
3. Updated the Product Identification System
section.
Revision E (November 2007)
• Removed preliminary watermark.
• Updated templates.
• Updated register information.
• Updated package outline drawings.
Revision D (April 2005)
• Added Table 8-1 and Table 8-2 in Section 8.0
“Oscillator”. Added note box following tables.
• Changed address bits in column heading in
Table 11-1, Section 11.0 “Register Map”.
• Modified Section 14.0 “Packaging Information”
to reflect pb free device markings.
• Appendix A Revision History: Rearranged order of
importance.
Revision C (November 2004)
• Section 9.0 “Reset” added.
• Heading 12.1: added notebox.
Heading 12.6: Changed verbiage within
paragraph in Section 12.0 “SPI Interface”.
• Added Appendix A: Revision History.
Revision B (September 2003)
• Front page bullet: Standby current (typical) (Sleep
mode) changed from 10 μA to 1 μA.
• Added notebox for maximum frequency on
CLKOUT in Section 8.2 “CLKOUT Pin”.
• Section 12.0 “SPI Interface”, Table 12-1:
- Changed supply voltage minimum to 2.7V.
- Internal Capacitance: Changed V
DD
condition
to 0V.
- Standby Current (Sleep mode): Split
specification into -40°C to +85°C and
-40°C to +125°C.
Revision A (May 2003)
• Original Release of this Document.