Datasheet

MCP1406/07
DS20002019C-page 4  2006-2016 Microchip Technology Inc.
1.0 ELECTRICAL
CHARACTERISTICS
Absolute Maximum Ratings †
Supply Voltage ................................................................+20V
Input Voltage ..................................(V
DD
+0.3V) to (GND -5V)
Input Current (V
IN
> V
DD
) ..............................................50 mA
Package Power Dissipation (TA <= +70°C)
DFN-S .......................................................................2.5W
PDIP..........................................................................1.2W
SOIC .......................................................................0.83W
TO-220......................................................................3.9W
ESD Protection on all Pins ................2 kV (HBM), 400V (MM)
† Notice: Stresses above those listed under “Maximum
Ratings” may cause permanent damage to the device.
This is a stress rating only and functional operation of
the device at those or any other conditions above those
indicated in the operational sections of this
specification is not intended. Exposure to maximum
rating conditions for extended periods may affect
device reliability.
DC CHARACTERISTICS
Electrical Specifications: Unless otherwise indicated, T
A
= +25°C, with 4.5VV
DD
18V.
Parameters Sym. Min. Typ. Max. Units Conditions
Input
Logic ‘1’, High Input Voltage V
IH
2.4 1.8 — V
Logic ‘0’, Low Input Voltage V
IL
—1.30.8 V
Input Current I
IN
–10 — 10 µA 0VV
IN
V
DD
Input Voltage V
IN
-5 — V
DD
+0.3 V
Output
High Output Voltage V
OH
V
DD
– 0.025 — — V DC Test
Low Output Voltage V
OL
— — 0.025 V DC Test
Output Resistance, High R
OH
—2.12.8  I
OUT
= 10 mA, V
DD
= 18V
Output Resistance, Low R
OL
—1.52.5  I
OUT
= 10 mA, V
DD
= 18V
Peak Output Current I
PK
—6 —AV
DD
 18V (Note 1)
Continuous Output Current I
DC
1.3 A Note 1, Note 2
Latch-Up Protection Withstand
Reverse Current
I
REV
— 1.5 — A Duty cycle2%, t 300 µs
Switching Time (Note 3)
Rise Time t
R
—20 30nsFigure 4-1, Figure 4-2
C
L
= 2500 pF
Fall Time t
F
—20 30nsFigure 4-1, Figure 4-2
C
L
= 2500 pF
Delay Time t
D1
—40 55nsFigure 4-1, Figure 4-2
Delay Time t
D2
—40 55nsFigure 4-1, Figure 4-2
Power Supply
Supply Voltage V
DD
4.5 — 18.0 V
Power Supply Current I
S
— 130 250 µA V
IN
= 3V
I
S
— 35 100 µA V
IN
= 0V
Note 1: Tested during characterization, not production tested.
2: Valid for AT (TO-220) and MF (DFN-S) packages only. T
A
= +25°C
3: Switching times ensured by design.