Datasheet

dsPIC33EPXXXGM3XX/6XX/7XX
DS70000689D-page 438  2013-2014 Microchip Technology Inc.
TABLE 33-8: DC CHARACTERISTICS: POWER-DOWN CURRENT (IPD)
DC CHARACTERISTICS
Standard Operating Conditions: 3.0V to 3.6V
(unless otherwise stated)
Operating temperature -40°C  T
A  +85°C for Industrial
-40°C  T
A  +125°C for Extended
Parameter
No.
Typ.
(2)
Max. Units Conditions
Power-Down Current (I
PD)
(1)
DC60d 35 100 A-40°C
3.3V Base Power-Down Current
DC60c 40 200 A+25°C
DC60b 250 500 A+85°C
DC60c 1000 2500 A +125°C
DC61d 8 10 A-40°C
3.3V Watchdog Timer Current: IWDT
(3)
DC61c 10 15 A+25°C
DC61b 12 20 A+85°C
DC61c 13 25 A +125°C
Note 1: I
PD (Sleep) current is measured as follows:
• CPU core is off, oscillator is configured in EC mode and external clock is active, OSC1 is driven with
external square wave from rail-to-rail (EC clock overshoot/undershoot < 250 mV required)
• CLKO is configured as an I/O input pin in the Configuration Word
• All I/O pins are configured as outputs and driving low
•MCLR
= VDD, WDT and FSCM are disabled
• All peripheral modules are disabled (PMDx bits are all ones)
• The VREGS bit (RCON<8>) = 0 (i.e., core regulator is set to standby while the device is in Sleep mode)
• The VREGSF bit (RCON<11>) = 0 (i.e., Flash regulator is set to standby while the device is in Sleep mode)
• JTAG is disabled
2: Data in the “Typical” column is at 3.3V, +25ºC unless otherwise specified.
3: The  current is the additional current consumed when the module is enabled. This current should be
added to the base I
PD current.