Datasheet

 2013-2014 Microchip Technology Inc. DS70000689D-page 437
dsPIC33EPXXXGM3XX/6XX/7XX
TABLE 33-7: DC CHARACTERISTICS: IDLE CURRENT (IIDLE)
DC CHARACTERISTICS
Standard Operating Conditions: 3.0V to 3.6V
(unless otherwise stated)
Operating temperature -40°C  T
A  +85°C for Industrial
-40°C  T
A  +125°C for Extended
Parameter
No.
Typ.
(2)
Max. Units Conditions
Idle Current (I
IDLE)
(1)
DC40d 1.5 8.0 mA -40°C
3.3V 10 MIPS
DC40a 1.5 8.0 mA +25°C
DC40b 1.5 8.0 mA +85°C
DC40c 1.5 8.0 mA +125°C
DC41d 2.0 12.0 mA -40°C
3.3V 20 MIPS
DC41a 2.0 12.0 mA +25°C
DC41b 2.0 12.0 mA +85°C
DC41c 2.0 12.0 mA +125°C
DC42d 5.5 15.0 mA -40°C
3.3V 40 MIPS
DC42a 5.5 15.0 mA +25°C
15.0DC42b 5.5 mA +85°C
15.0DC42c 5.5 mA +125°C
DC43d 9.0 20.0 mA -40°C
3.3V 60 MIPS
DC43a 9.0 20.0 mA +25°C
20.0DC43b 9.0 mA +85°C
20.0DC43c 9.0 mA +125°C
DC44d 10.0 25.0 mA -40°C
3.3V 70 MIPSDC44a 10.0 25.0 mA +25°C
25.0DC44b 10.0 mA +85°C
Note 1: Base Idle current (I
IDLE) is measured as follows:
• CPU core is off, oscillator is configured in EC mode and external clock is active, OSC1 is driven with
external square wave from rail-to-rail (EC clock overshoot/undershoot < 250 mV required)
• CLKO is configured as an I/O input pin in the Configuration Word
• All I/O pins are configured as outputs and driving low
•M
CLR = VDD, WDT and FSCM are disabled
• No peripheral modules are operating or being clocked (defined PMDx bits are all ones)
• The NVMSIDL bit (NVMCON<12>) = 1 (i.e., Flash regulator is set to standby while the device is in
Idle mode)
• The VREGSF bit (RCON<11>) = 0 (i.e., Flash regulator is set to standby while the device is in Sleep
mode)
• JTAG is disabled
2: Data in the “Typical” column is at 3.3V, +25°C unless otherwise specified.