Datasheet

 2013-2014 Microchip Technology Inc. DS70000689D-page 111
dsPIC33EPXXXGM3XX/6XX/7XX
6.0 RESETS
The Reset module combines all Reset sources and
controls the device Master Reset Signal, SYSRST
. The
following is a list of device Reset sources:
• POR: Power-on Reset
• BOR: Brown-out Reset
•MCLR: Master Clear Pin Reset
•SWR: RESET Instruction
• WDTO: Watchdog Timer Time-out Reset
• CM: Configuration Mismatch Reset
• TRAPR: Trap Conflict Reset
• IOPUWR: Illegal Condition Device Reset
- Illegal Opcode Reset
- Illegal Address Mode Reset
- Uninitialized W Register Reset
- Security Reset
A simplified block diagram of the Reset module is
shown in Figure 6-1.
Any active source of Reset will make the SYSRST
signal active. On system Reset, some of the registers
associated with the CPU and peripherals are forced to
a known Reset state and some are unaffected.
All types of device Reset set a corresponding status bit
in the RCON register to indicate the type of Reset (see
Register 6-1).
A POR clears all the bits, except for the POR and BOR
bits (RCON<1:0>) that are set. The user application
can set or clear any bit at any time during code
execution. The RCON bits only serve as status bits.
Setting a particular Reset status bit in software does
not cause a device Reset to occur.
The RCON register also has other bits associated with
the Watchdog Timer and device power-saving states.
The function of these bits is discussed in other sections
of this manual.
FIGURE 6-1: RESET SYSTEM BLOCK DIAGRAM
Note 1: This data sheet summarizes the features
of the dsPIC33EPXXXGM3XX/6XX/7XX
family of devices. It is not intended to be a
comprehensive reference source. To com-
plement the information in this data sheet,
refer to the “dsPIC33/PIC24 Family Refer-
ence Manual”, “Reset” (DS70602), which
is available from the Microchip web site
(www.microchip.com).
2: Some registers and associated bits
described in this section may not be
available on all devices. Refer to
Section 4.0 “Memory Organization” in
this data sheet for device-specific register
and bit information.
Note: Refer to the specific peripheral section or
Section 4.0 “Memory Organization” of
this manual for register Reset states.
Note: The status bits in the RCON register
should be cleared after they are read so
that the next RCON register value after a
device Reset is meaningful.
Note: In all types of Resets, to select the device
clock source, the contents of OSCCON are
initialized from the FNOSCx Configuration
bits in the FOSCSEL Configuration register.
MCLR
VDD
BOR
Sleep or Idle
RESET Instruction
WDT
Module
Glitch Filter
Trap Conflict
Illegal Opcode
Uninitialized W Register
SYSRST
VDD Rise
Detect
POR
Configuration Mismatch
Security Reset
Internal
Regulator
Illegal Address Mode