Datasheet

 2018 Microchip Technology Inc. Data Sheet Complete DS40002058A-page 24
ATxmega128A1U/ATxmega64A1U
9. Event System
9.1 Features
 System for direct peripheral-to-peripheral communication and signaling
 Peripherals can directly send, receive, and react to peripheral events
 CPU and DMA controller independent operation
 100% predictable signal timing
 Short and guaranteed response time
 Eight event channels for up to eight different and parallel signal routing configurations
 Events can be sent and/or used by most peripherals, clock system, and software
 Additional functions include
 Quadrature decoders
 Digital filtering of I/O pin state
 Works in active mode and idle sleep mode
9.2 Overview
The event system enables direct peripheral-to-peripheral communication and signaling. It allows a change in one periph-
eral’s state to automatically trigger actions in other peripherals. It is designed to provide a predictable system for short and
predictable response times between peripherals. It allows for autonomous peripheral control and interaction without the
use of interrupts, CPU, or DMA controller resources, and is thus a powerful tool for reducing the complexity, size and exe-
cution time of application code. It also allows for synchronized timing of actions in several peripheral modules.
A change in a peripheral’s state is referred to as an event, and usually corresponds to the peripheral’s interrupt conditions.
Events can be directly passed to other peripherals using a dedicated routing network called the event routing network. How
events are routed and used by the peripherals is configured in software.
Figure 9-1 on page 24 shows a basic diagram of all connected peripherals. The event system can directly connect together
analog and digital converters, analog comparators, I/O port pins, the real-time counter, timer/counters, IR communication
module (IRCOM), and USB interface. It can also be used to trigger DMA transactions (DMA controller). Events can also be
generated from software and the peripheral clock.
Figure 9-1. Event system overview and connected peripherals.
The event routing network consists of eight software-configurable multiplexers that control how events are routed and
used. These are called event channels, and allow for up to eight parallel event routing configurations. The maximum rout-
ing latency is two peripheral clock cycles. The event system works in both active mode and idle sleep mode.
DAC
Timer /
Counters
USB
ADC
Real Time
Counter
Port pins
CPU /
Software
DMA
Controller
IRCOM
Event Routing Network
Event
System
Controller
clk
PER
Prescaler
AC