Datasheet

 2018 Microchip Technology Inc. Data Sheet Complete DS40002060A-page 117

ATtiny4/5/9/10

Notes: 1. This section is read-only.

16.3.3 Configuration Section

ATtiny4/5/9/10 have one configuration byte, which resides in the configuration section. See Table 16-5.

Table 16-6 briefly describes the functionality of all configuration bits and how they are mapped into the configuration byte.

Configuration bits are not affected by a chip erase but they can be cleared using the configuration section erase command

(see “Erasing the Configuration Section” on page 120). Note that configuration bits are locked if Non-Volatile Lock Bit 1

(NVLB1) is programmed.

16.3.3.1 Latching of Configuration Bits

All configuration bits are latched either when the device is reset or when the device exits the external programming mode.

Changes to configuration bit values have no effect until the device leaves the external programming mode.

Table 16-4. Number of Words and Pages in the Flash (ATtiny4/5)

Section Size (Bytes) Page Size (Words) Pages WADDR PADDR

Code (program memory) 512 8 32 [3:1] [9:4]

Configuration 8 8 1 [3:1] –

Signature

(1)

16 8 2 [3:1] [4:4]

Calibration

(1)

8 8 1 [3:1] –

Table 16-5. Configuration bytes

Configuration word address

Configuration word data

High byte Low byte

0x00 Reserved Configuration Byte 0

0x01 ... 0x07 Reserved Reserved

Table 16-6. Configuration Byte 0

Bit Bit Name Description Default Value

7:3 – Reserved 1 (unprogrammed)

2 CKOUT System Clock Output 1 (unprogrammed)

1 WDTON Watchdog Timer always on 1 (unprogrammed)

0 RSTDISBL External Reset disable 1 (unprogrammed)