Datasheet

Note:
1.
To select this extra function, refer to the 32.5.14 Parallel Capture Mode section in the Parallel Input/Output
Controller (PIO) chapter.
2. PIODCEN1/PIODCx has priority over WKUPx. Refer to the 32.5.14 Parallel Capture Mode section in the PIO
chapter.
3. Refer to the 23.4.2 Slow Clock Generator section in the Supply Controller (SUPC) chapter.
4. To select this extra function, refer to the 33.5.2.1 I/O Lines section in the External Bus Interface (EBI) chapter.
This selection is independent of the PIO line configuration. PIO lines must be configured according to required
settings (PU or PD).
5. Analog input has priority over WKUPx pin. To select the analog input, refer to the 33.5.2.1 I/O Lines section in
the EBI chapter. WKUPx can be used if the PIO controller defines the I/O line as “input”.
6. Analog input has priority over RTCOUTx pin. To select the analog input, refer to the 33.5.2.1 I/O Lines section
in the EBI chapter. Refer to the 27.5.8 Waveform Generation section in the Real-Time Clock (RTC) chapter to
select RTCOUTx.
7. Analog input has priority over WKUPx pin. To select the analog input, refer to the 33.5.2.1 I/O Lines section in
the EBI chapter. To select PIODCEN2, refer to the 32.5.14 Parallel Capture Mode in the PIO chapter.
8. Refer to the System I/O Configuration Register (19.4.7 CCFG_SYSIO) in the Bus Matrix (MATRIX) chapter.
9. Refer to the 30.5.3 Main Crystal Oscillator section in the Clock Generator chapter. This selection is
independent of the PIO line configuration. PIO lines must be configured according to XINxx (I) and XOUTxx
(O).
10. DAC0 is selected when DACC_CHER.CH0 is set. DAC1 is selected when DACC_CHER.CH1 is set. Refer to
the DACC Channel Enable Register in the Digital-to-Analog Converter Controller (DACC) chapter.
11. The exposed pad of the QFN64 package MUST be connected to ground.
SAM E70/S70/V70/V71 Family
Package and Pinout
© 2019 Microchip T
echnology Inc.
Datasheet
DS60001527D-page 43