Datasheet

...........continued
Symbol Parameter Conditions Min. Typ. Max. Unit
V
DDUTMII
DC Supply
UDPHS and
UHPHS UTMI
+ Interface
– 3.0 3.3 3.6 V
Allowable
V
oltage Ripple
rms value 10
kHz to 10 MHz
– – 20 mV
V
DDPLLUSB
DC Supply
UTMI PLL
– 3.0 3.3 3.6 V
Allowable
Voltage Ripple
rms value 10
kHz to 10 MHz
– – 10 mV
Note:
1.
V
DDIO
voltage must be equal to V
DDIN
voltage.
Table 59-4. DC Characteristics
Symbol Parameter Conditions Min. Typ. Max. Unit
V
IL
Low-level Input Voltage GPIO_MLB -0.3 – 0.7 V
GPIO_AD, GPIO_CLK -0.3 – 0.8
GPIO, CLOCK, RST, TEST -0.3 – V
DDIO
x 0.3
V
IH
High-level Input Voltage GPIO_MLB 1.80 – V
DDIO
+ 0.3 V
GPIO_AD, GPIO_CLK 2 V
DDIO
+ 0.3
GPIO, CLOCK, RST, TEST V
DDIO
x 0.7 – V
DDIO
+ 0.3
V
OH
High-level Output Voltage GPIO_MLB , IOH = 6 mA 2 – – V
GPIO_AD, GPIO, RST, TEST,
CLOCK ,IOH = 4 mA, Low drive
V
DDIO
- 0.4 – –
GPIO_AD, GPIO, RST, TEST,
CLOCK ,IOH = 10 mA, High drive
V
DDIO
- 0.4 – –
GPIO_CLK, IOH = 6 mA, Low drive V
DDIO
- 0.4
GPIO_CLK, IOH = 12 mA, High drive V
DDIO
- 0.4 – –
V
OL
Low-level Output Voltage GPIO_MLB, IOL = -6 mA – – 0.4 V
GPIO_AD, GPIO, RST, TEST, CLOCK,
IOL = -4 mA, Low drive
– – 0.4
GPIO_AD, GPIO, RST, TEST, CLOCK,
IOL = -10 mA,High drive
– – 0.4
GPIO_CLK, IOL = -6 mA, Low drive – – 0.4
GPIO_CLK, IOL = -12 mA, High drive – – 0.4
V
hys
Hysteresis Voltage GPIO with Hysteresis mode enabled 150 – – mV
I
IL
Low-level Input Current Pullup OFF -1 – 1 µA
Pullup ON 10 – 55
SAM E70/S70/V70/V71 Family
Electrical Characteristics for SAM E70/S70
© 2019 Microchip T
echnology Inc.
Datasheet
DS60001527D-page 1865