Datasheet

31.8.5 Fault Control A and B
Name: FCTRLA, FCTRLB
Offset: 0x0C + n*0x04 [n=0..1]
Reset: 0x00000000
Property: PAC Write-Protection, Enable-Protected
Bit 31 30 29 28 27 26 25 24
FILTERVAL[3:0]
Access
R/W R/W R/W R/W
Reset 0 0 0 0
Bit 23 22 21 20 19 18 17 16
BLANKVAL[7:0]
Access
R/W R/W R/W R/W R/W R/W R/W R/W
Reset 0 0 0 0 0 0 0 0
Bit 15 14 13 12 11 10 9 8
CAPTURE[2:0] CHSEL[1:0] HALT[1:0]
Access
R/W R/W R/W R/W R/W R/W R/W
Reset 0 0 0 0 0 0 0
Bit 7 6 5 4 3 2 1 0
RESTART BLANK[1:0] QUAL KEEP SRC[1:0]
Access
R/W R/W R/W R/W R/W R/W R/W
Reset 0 0 0 0 0 0 0
Bits 27:24 – FILTERVAL[3:0] Recoverable Fault n Filter Value
These bits define the filter value applied on MCEx (x=0,1) event input line. The value must be set to zero
when MCEx event is used as synchronous event.
Bits 23:16 – BLANKVAL[7:0] Recoverable Fault n Blanking Value
These bits determine the duration of the blanking of the fault input source. Activation and edge selection
of the blank filtering are done by the BLANK bits (FCTRLn.BLANK).
When enabled, the fault input source is internally disabled for BLANKVAL* prescaled GCLK_TCC periods
after the detection of the waveform edge.
Bits 14:12 – CAPTURE[2:0] Recoverable Fault n Capture Action
These bits select the capture and Fault n interrupt/event conditions.
Table 31-8. Fault n Capture Action
Value Name Description
0x0 DISABLE Capture on valid recoverable Fault n is disabled
0x1 CAPT On rising edge of a valid recoverable Fault n, capture counter value on channel
selected by CHSEL[1:0].
INTFLAG.FAULTn flag rises on each new captured value.
SAM D21 Family
TCC – Timer/Counter for Control Applications
© 2018 Microchip Technology Inc.
Datasheet Complete
DS40001882D-page 754