Datasheet

27.6.3 Additional Features
27.6.3.1 Address Recognition
When the SPI is configured for slave operation (CTRLA.MODE=0x2) with address recognition
(CTRLA.FORM is 0x2), the SERCOM address recognition logic is enabled: the first character in a
transaction is checked for an address match.
If there is a match, the Receive Complete Interrupt flag in the Interrupt Flag Status and Clear register
(INTFLAG.RXC) is set, the MISO output is enabled, and the transaction is processed. If the device is in
sleep mode, an address match can wake up the device in order to process the transaction.
If there is no match, the complete transaction is ignored.
If a 9-bit frame format is selected, only the lower 8 bits of the shift register are checked against the
Address register (ADDR).
Preload must be disabled (CTRLB.PLOADEN=0) in order to use this mode.
Related Links
25.6.3.1 Address Match and Mask
27.6.3.2 Preloading of the Slave Shift Register
When starting a transaction, the slave will first transmit the contents of the shift register before loading
new data from DATA. The first character sent can be either the reset value of the shift register (if this is
the first transmission since the last reset) or the last character in the previous transmission.
Preloading can be used to preload data into the shift register while SS is high: this eliminates sending a
dummy character when starting a transaction. If the shift register is not preloaded, the current contents of
the shift register will be shifted out.
Only one data character will be preloaded into the shift register while the synchronized SS signal is high.
If the next character is written to DATA before SS is pulled low, the second character will be stored in
DATA until transfer begins.
For proper preloading, sufficient time must elapse between SS going low and the first SCK sampling
edge, as in Timing Using Preloading. See also Electrical Characteristics for timing details.
Preloading is enabled by writing '1' to the Slave Data Preload Enable bit in the CTRLB register
(CTRLB.PLOADEN).
Figure 27-4. Timing Using Preloading
_SS
_SS synchronized
to system domain
SCK
Synchronization
to system domain
MISO to SCK
setup time
Required _SS-to-SCK time
using PRELOADEN
Related Links
37. Electrical Characteristics
SAM D21 Family
SERCOM SPI – SERCOM Serial Peripheral Interface
© 2018 Microchip Technology Inc.
Datasheet Complete
DS40001882D-page 518