Datasheet

23.8.6 Data Output Value Clear
Name: OUTCLR
Offset: 0x14
Reset: 0x00000000
Property: PAC Write-Protection
This register allows the user to set one or more output I/O pin drive levels low, without doing a read-
modify-write operation. Changes in this register will also be reflected in the Data Output Value (OUT),
Data Output Value Toggle (OUTTGL) and Data Output Value Set (OUTSET) registers.
Tip: The I/O pins are assembled in pin groups (”PORT groups”) with up to 32 pins. Group 0
consists of the PA pins, group 1 is for the PB pins, etc. Each pin group has its own PORT
registers, with a 0x80 address spacing. For example, the register address offset for the Data
Direction (DIR) register for group 0 (PA00 to PA31) is 0x00, and the register address offset for
the DIR register for group 1 (PB00 to PB31) is 0x80.
Bit 31 30 29 28 27 26 25 24
OUTCLR[31:24]
Access
RW RW RW RW RW RW RW RW
Reset 0 0 0 0 0 0 0 0
Bit 23 22 21 20 19 18 17 16
OUTCLR[23:16]
Access
RW RW RW RW RW RW RW RW
Reset 0 0 0 0 0 0 0 0
Bit 15 14 13 12 11 10 9 8
OUTCLR[15:8]
Access
RW RW RW RW RW RW RW RW
Reset 0 0 0 0 0 0 0 0
Bit 7 6 5 4 3 2 1 0
OUTCLR[7:0]
Access
RW RW RW RW RW RW RW RW
Reset 0 0 0 0 0 0 0 0
Bits 31:0 – OUTCLR[31:0] PORT Data Output Value Clear
Writing '0' to a bit has no effect.
Writing '1' to a bit will clear the corresponding bit in the OUT register. Pins configured as outputs via the
Data Direction register (DIR) will be set to low output drive level. Pins configured as inputs via DIR and
with pull enabled via the Pull Enable bit in the Pin Configuration register (PINCFG.PULLEN) will set the
input pull direction to an internal pull-down.
Value Description
0
The corresponding I/O pin in the PORT group will keep its configuration.
SAM D21 Family
PORT - I/O Pin Controller
© 2018 Microchip Technology Inc.
Datasheet Complete
DS40001882D-page 423