Datasheet

ongoing one is done. Only one pending transfer can be kept per channel. If the trigger source generates
more transfer requests while one is already pending, the additional ones will be lost. All channels pending
status flags are also available in the Pending Channels register (PENDCH).
When the transfer starts, the corresponding Channel Busy status flag is set in Channel Status register
(CHSTATUS.BUSY). When the trigger action is complete, the Channel Busy status flag is cleared. All
channel busy status flags are also available in the Busy Channels register (BUSYCH) in DMAC.
20.6.2.7 Addressing
Each block transfer needs to have both a source address and a destination address defined. The source
address is set by writing the Transfer Source Address (SRCADDR) register, the destination address is set
by writing the Transfer Destination Address (SRCADDR) register.
The addressing of this DMAC module can be static or incremental, for either source or destination of a
block transfer, or both.
Incrementation for the source address of a block transfer is enabled by writing the Source Address
Incrementation Enable bit in the Block Transfer Control register (BTCTRL.SRCINC=1). The step size of
the incrementation is configurable and can be chosen by writing the Step Selection bit in the Block
Transfer Control register (BTCTRL.STEPSEL=1) and writing the desired step size in the Address
Increment Step Size bit group in the Block Transfer Control register (BTCTRL.STEPSIZE). If
BTCTRL.STEPSEL=0, the step size for the source incrementation will be the size of one beat.
When source address incrementation is configured (BTCTRL.SRCINC=1), SRCADDR is calculated as
follows:
If BTCTRL.STEPSEL=1:
SRCADDR = SRCADDR

+    + 1  2
STEPSIZE
If BTCTRL.STEPSEL=0:
SRCADDR = SRCADDR

+    + 1
• SRCADDR
START
is the source address of the first beat transfer in the block transfer
• BTCNT is the initial number of beats remaining in the block transfer
• BEATSIZE is the configured number of bytes in a beat
• STEPSIZE is the configured number of beats for each incrementation
The following figure shows an example where DMA channel 0 is configured to increment the source
address by one beat after each beat transfer (BTCTRL.SRCINC=1), and DMA channel 1 is configured to
increment the source address by two beats (BTCTRL.SRCINC=1, BTCTRL.STEPSEL=1, and
BTCTRL.STEPSIZE=0x1). As the destination address for both channels are peripherals, destination
incrementation is disabled (BTCTRL.DSTINC=0).
SAM D21 Family
DMAC – Direct Memory Access Controller
© 2018 Microchip Technology Inc.
Datasheet Complete
DS40001882D-page 312