Datasheet

39. Electrical Characteristics at 125°C
39.1 Disclaimer
All typical values are measured at T = 25°C unless otherwise specified. All minimum and maximum
values are valid across operating temperature and voltage unless otherwise specified.
39.2 Absolute Maximum Ratings
Stresses beyond those listed in the table below may cause permanent damage to the device. This is a
stress rating only and functional operation of the device at these or other conditions beyond those
indicated in the operational sections of this specification is not implied. Exposure to absolute maximum
rating conditions for extended periods may affect device reliability.
Table 39-1. Absolute Maximum Ratings
Symbol Parameter Condition Min. Max. Units
V
DD
Power supply voltage 0 3.8 V
I
VDD
Current into a V
DD
pin - 28
(1)
mA
I
GND
Current out of a GND pin - 39
(1)
mA
V
PIN
Pin voltage with respect to GND and V
DD
GND-0.6V V
DD
+0.6V V
T
storage
Storage temperature -60 150 °C
Note:
1. Maximum source current is 14mA and maximum sink current is 19.5mA per cluster. A cluster is a
group of GPIOs, see related links. Also note that each VDD/GND pair is connected to 2 clusters so
current consumption through the pair will be a sum of the clusters source/sink currents.
Related Links
7.2.4 GPIO Clusters
39.3 General Operating Ratings
The device must operate within the ratings in order for all other electrical characteristics and typical
characteristics of the device to be valid.
Table 39-2. General Operating Conditions
Symbol Parameter Condition Min. Typ. Max. Units
V
DD
Power supply voltage 1.62(1) 3.3 3.63 V
V
DDANA
Analog supply voltage 1.62(1) 3.3 3.63 V
T
A
Temperature range -40 25 125 °C
T
J
Junction temperature - - 145 °C
Note:
SAM D21 Family
Electrical Characteristics at 125°C
© 2018 Microchip Technology Inc.
Datasheet Complete
DS40001882D-page 1065