Datasheet

803
SAM3X / SAM3A [DATASHEET]
Atmel-11057C-ATARM-SAM3X-SAM3A-Datasheet_23-Mar-15
 if the internal clock divided (MCK/DIV) is selected, the value programmed in CD must be even to ensure a
50:50 mark/space ratio on the SCK pin, this value can be odd if the internal clock is selected (MCK).
In SPI Slave Mode:
 the external clock (SCK) selection is forced regardless of the value of the USCLKS field in the Mode
Register (US_MR). Likewise, the value written in US_BRGR has no effect, because the clock is provided
directly by the signal on the USART SCK pin.
 to obtain correct behavior of the receiver and the transmitter, the external clock (SCK) frequency must be at
least 6 times lower than the system clock.
35.7.7.3 Data Transfer
Up to 9 data bits are successively shifted out on the TXD pin at each rising or falling edge (depending of CPOL and
CPHA) of the programmed serial clock. There is no Start bit, no Parity bit and no Stop bit.
The number of data bits is selected by the CHRL field and the MODE 9 bit in the Mode Register (US_MR). The 9
bits are selected by setting the MODE 9 bit regardless of the CHRL field. The MSB data bit is always sent first in
SPI Mode (Master or Slave).
Four combinations of polarity and phase are available for data transfers. The clock polarity is programmed with the
CPOL bit in the Mode Register. The clock phase is programmed with the CPHA bit. These two parameters
determine the edges of the clock signal upon which data is driven and sampled. Each of the two parameters has
two possible states, resulting in four possible combinations that are incompatible with one another. Thus, a
master/slave pair must use the same parameter pair values to communicate. If multiple slaves are used and fixed
in different configurations, the master must reconfigure itself each time it needs to communicate with a different
slave.
Table 35-14. SPI Bus Protocol Mode
SPI Bus Protocol Mode CPOL CPHA
001
100
211
310