Datasheet

795
SAM3X / SAM3A [DATASHEET]
Atmel-11057C-ATARM-SAM3X-SAM3A-Datasheet_23-Mar-15
Figure 35-27. Connection with a Remote Device for Hardware Handshaking
Setting the USART to operate with hardware handshaking is performed by writing the USART_MODE field in the
Mode Register (US_MR) to the value 0x2.
The USART behavior when hardware handshaking is enabled is the same as the behavior in standard
synchronous or asynchronous mode, except that the receiver drives the RTS pin as described below and the level
on the CTS pin modifies the behavior of the transmitter as described below. Using this mode requires using the
PDC channel for reception. The transmitter can handle hardware handshaking in any case.
Figure 35-28 shows how the receiver operates if hardware handshaking is enabled. The RTS pin is driven high if
the receiver is disabled and if the status RXBUFF (Receive Buffer Full) coming from the PDC channel is high.
Normally, the remote device does not start transmitting while its CTS pin (driven by RTS) is high. As soon as the
Receiver is enabled, the RTS falls, indicating to the remote device that it can start transmitting. Defining a new
buffer to the PDC clears the status bit RXBUFF and, as a result, asserts the pin RTS low.
Figure 35-28. Receiver Behavior when Operating with Hardware Handshaking
Figure 35-29 shows how the transmitter operates if hardware handshaking is enabled. The CTS pin disables the
transmitter. If a character is being processing, the transmitter is disabled only after the completion of the current
character and transmission of the next character happens as soon as the pin CTS falls.
Figure 35-29. Transmitter Behavior when Operating with Hardware Handshaking
35.7.4 ISO7816 Mode
The USART features an ISO7816-compatible operating mode. This mode permits interfacing with smart cards and
Security Access Modules (SAM) communicating through an ISO7816 link. Both T = 0 and T = 1 protocols defined
by the ISO7816 specification are supported.
Setting the USART in ISO7816 mode is performed by writing the USART_MODE field in the Mode Register
(US_MR) to the value 0x4 for protocol T = 0 and to the value 0x5 for protocol T = 1.
USART
TXD
CTS
Remote
Device
RXD
TXDRXD
RTS
RTS
CTS
RTS
RXBUFF
Write
US_CR
RXEN = 1
RXD
RXDIS = 1
CTS
TXD