Datasheet

SAM3X / SAM3A [DATASHEET]
Atmel-11057C-ATARM-SAM3X-SAM3A-Datasheet_23-Mar-15
790
Table 35-9 shows an example of the parity bit for the character 0x41 (character ASCII “A”) depending on the
configuration of the USART. Because there are two bits to 1, 1 bit is added when a parity is odd, or 0 is added
when a parity is even.
When the receiver detects a parity error, it sets the PARE (Parity Error) bit in the Channel Status Register
(US_CSR). The PARE bit can be cleared by writing the Control Register (US_CR) with the RSTSTA bit to 1. Figure
35-22 illustrates the parity bit status setting and clearing.
Figure 35-22. Parity Error
35.7.3.9 Multidrop Mode
If the PAR field in the Mode Register (US_MR) is programmed to the value 0x6 or 0x07, the USART runs in
Multidrop Mode. This mode differentiates the data characters and the address characters. Data is transmitted with
the parity bit to 0 and addresses are transmitted with the parity bit to 1.
If the USART is configured in multidrop mode, the receiver sets the PARE parity error bit when the parity bit is high
and the transmitter is able to send a character with the parity bit high when the Control Register is written with the
SENDA bit to 1.
To handle parity error, the PARE bit is cleared when the Control Register is written with the bit RSTSTA to 1.
The transmitter sends an address byte (parity bit set) when SENDA is written to US_CR. In this case, the next byte
written to US_THR is transmitted as an address. Any character written in US_THR without having written the
command SENDA is transmitted normally with the parity to 0.
35.7.3.10 Transmitter Timeguard
The timeguard feature enables the USART interface with slow remote devices.
The timeguard function enables the transmitter to insert an idle state on the TXD line between two characters. This
idle state actually acts as a long stop bit.
Table 35-9. Parity Bit Examples
Character Hexa Binary Parity Bit Parity Mode
A 0x41 0100 0001 1 Odd
A 0x41 0100 0001 0 Even
A 0x41 0100 0001 1 Mark
A 0x41 0100 0001 0 Space
A 0x41 0100 0001 None None
D0 D1 D2 D3 D4 D5 D6 D7
RXD
Start
Bit
Bad
Parity
Bit
Stop
Bit
Baud Rate
Clock
Write
US_CR
PARE
RXRDY
RSTSTA = 1