Datasheet

SAM3X / SAM3A [DATASHEET]
Atmel-11057C-ATARM-SAM3X-SAM3A-Datasheet_23-Mar-15
754
34.5.2.4 Receiver Overrun
If UART_RHR has not been read by the software (or the Peripheral Data Controller or DMA Controller) since the
last transfer, the RXRDY bit is still set and a new character is received, the OVRE status bit in UART_SR is set.
OVRE is cleared when the software writes the control register UART_CR with the bit RSTSTA (Reset Status) at 1.
Figure 34-6. Receiver Overrun
34.5.2.5 Parity Error
Each time a character is received, the receiver calculates the parity of the received data bits, in accordance with
the field PAR in UART_MR. It then compares the result with the received parity bit. If different, the parity error bit
PARE in UART_SR is set at the same time the RXRDY is set. The parity bit is cleared when the control register
UART_CR is written with the bit RSTSTA (Reset Status) at 1. If a new character is received before the reset status
command is written, the PARE bit remains at 1.
Figure 34-7. Parity Error
34.5.2.6 Receiver Framing Error
When a start bit is detected, it generates a character reception when all the data bits have been sampled. The stop
bit is also sampled and when it is detected at 0, the FRAME (Framing Error) bit in UART_SR is set at the same
time the RXRDY bit is set. The FRAME bit remains high until the control register UART_CR is written with the bit
RSTSTA at 1.
Figure 34-8. Receiver Framing Error
D0 D1 D2 D3 D4 D5 D6 D7 PS
S
D0 D1 D2 D3 D4 D5 D6 D7 P
URXD
RSTSTA
RXRDY
OVRE
stop
stop
stop
D0 D1 D2 D3 D4 D5 D6 D7 PS
URXD
RSTSTA
RXRDY
PARE
Wrong Parity Bit
D0 D1 D2 D3 D4 D5 D6 D7 PS
URXD
RSTSTA
RXRDY
FRAME
Stop Bit
Detected at 0
stop