Datasheet

587
SAM3X / SAM3A [DATASHEET]
Atmel-11057C-ATARM-SAM3X-SAM3A-Datasheet_23-Mar-15
30.7.8 Loop Mode
The receiver can be programmed to receive transmissions from the transmitter. This is done by setting the Loop
Mode (LOOP) bit in SSC_RFMR. In this case, RD is connected to TD, RF is connected to TF and RK is connected
to TK.
30.7.9 Interrupt
Most bits in SSC_SR have a corresponding bit in interrupt management registers.
The SSC can be programmed to generate an interrupt when it detects an event. The interrupt is controlled by
writing SSC_IER (Interrupt Enable Register) and SSC_IDR (Interrupt Disable Register) These registers enable
and disable, respectively, the corresponding interrupt by setting and clearing the corresponding bit in SSC_IMR
(Interrupt Mask Register), which controls the generation of interrupts by asserting the SSC interrupt line connected
to the NVIC.
Figure 30-16. Interrupt Block Diagram
SSC_IMR
Interrupt
Control
SSC Interrupt
Set
RXRDY
OVRUN
RXSYNC
Receiver
Transmitter
TXRDY
TXEMPTY
TXSYNC
Clear
SSC_IER
SSC_IDR