Datasheet

A frequency waveform output with 50% duty cycle can be achieved in Fast PWM mode by selecting
OC0x to toggle its logical level on each compare match (COM0x[1:0]=0x1). The waveform generated will
have a maximum frequency of f
OC0
= f
clk_I/O
/2 when OCR0A=0x00. This feature is similar to the OC0A
toggle in CTC mode, except double buffering of the Output Compare unit is enabled in the Fast PWM
mode.
16.7.4. Phase Correct PWM Mode
The Phase Correct PWM mode (WGM0[2:0]=0x1 or WGM0[2:0]=0x5) provides a high resolution, phase
correct PWM waveform generation. The Phase Correct PWM mode is based on dual-slope operation:
The counter counts repeatedly from BOTTOM to TOP, and then from TOP to BOTTOM. When
WGM0[2:0]=0x1 TOP is defined as 0xFF. When WGM0[2:0]=0x5, TOP is defined as OCR0A. In non-
inverting Compare Output mode, the Output Compare (OC0x) bit is cleared on compare match between
TCNT0 and OCR0x while up-counting, and OC0x is set on the compare match while down-counting. In
inverting Output Compare mode, the operation is inverted. The dual-slope operation has a lower
maximum operation frequency than single slope operation. Due to the symmetric feature of the dual-slope
PWM modes, these modes are preferred for motor control applications.
In Phase Correct PWM mode the counter is incremented until the counter value matches TOP. When the
counter reaches TOP, it changes the count direction. The TCNT0 value will be equal to TOP for one timer
clock cycle. The timing diagram for the Phase Correct PWM mode is shown below. The TCNT0 value is
shown as a histogram for illustrating the dual-slope operation. The diagram includes non-inverted and
inverted PWM outputs. The small horizontal line marks on the TCNT0 slopes represent compare matches
between OCR0x and TCNT0.
Figure 16-7. Phase Correct PWM Mode, Timing Diagram
TOVn Interrupt Flag Set
OCnx Interrupt Flag Set
1 2 3
TCNTn
Period
OCnx
OCnx
(COMnx[1:0] = 2)
(COMnx[1:0] = 3)
OCRnx Update
Note: The “n” in the register and bit names indicates the device number (n = 0 for Timer/Counter 0), and
the “x” indicates Output Compare unit (A/B).
The Timer/Counter Overflow Flag (TOV0) is set each time the counter reaches BOTTOM. The Interrupt
Flag can be used to generate an interrupt each time the counter reaches the BOTTOM value.
In Phase Correct PWM mode, the compare unit allows generation of PWM waveforms on the OC0x pin.
Writing the COM0x[1:0] bits to 0x2 will produce a non-inverted PWM. An inverted PWM output can be
generated by writing COM0x[1:0]=0x3. Setting the Compare Match Output A Mode bit to '1'
(TCCR0A.COM0A0) allows the OC0A pin to toggle on Compare Matches if the TCCR0B.WGM02 bit is
Atmel ATmega644A [DATASHEET]
Atmel-42716C-ATmega644A_Datasheet_Complete-10/2016
136