Datasheet

172
ATmega16U4/32U4 [DATASHEET]
Atmel-7766J-USB-ATmega16U4/32U4-Datasheet_04/2016
• Bit 6- ENHC4: Enhanced Compare/PWM Mode
When this bit is set, the Waveform Generation Module works in enhanced mode: the compare registers
OCR4A/B/D can welcome one more accuracy bit, while the LSB determines on which clock edge the Compare
condition is signalled and the output pin level is updated.
• Bits 5:0 – OC4OE5:OC4OE0: Output Compare Override Enable Bits
These bits are the Output Compare Override Enable bits that are used to connect or disconnect the Output
Compare Pins in PWM6 Modes with an instant response on the corresponding Output Compare Pins. The
actual value from the port register will be visible on the port pin, when the Output Compare Override Enable Bit
is cleared. The table shows the Output Compare Override Enable Bits and their corresponding Output Compare
pins.
15.12.6 TCNT4 – Timer/Counter4
This 8-bit register contains the value of Timer/Counter4.
The Timer/Counter4 is realized as a 10-bit up/down counter with read and write access. Due to synchronization
of the CPU, Timer/Counter4 data written into Timer/Counter4 is delayed by one and half CPU clock cycles in
synchronous mode and at most one CPU clock cycles for asynchronous mode. When a 10-bit accuracy is
preferred, special procedures must be followed for accessing the 10-bit TCNT4 register via the 8-bit AVR data
bus. These procedures are described in section “Accessing 10-bit Registers” on page 160. Alternatively the
Timer/Counter4 can be used as an 8-bit Timer/Counter. Note that the Timer/Counter4 always starts counting up
after writing the TCNT4 register.
15.12.7 TC4H – Timer/Counter4 High Byte
The temporary Timer/Counter4 register is an 2-bit read/write register.
• Bits 7:3- Res: Reserved Bits
These bits are reserved bits and always reads as zero.
• Bits 2- TC410: Additional MSB bits for 11-bit accesses in Enhanced PWM mode
If 10-bit accuracy is used, the Timer/Counter4 High Byte Register (TC4H) is used for temporary storing the MSB
bits (TC49, TC48) of the 10-bit accesses. The same TC4H register is shared between all 10-bit registers within
the Timer/Counter4. Note that special procedures must be followed when accessing the 10-bit TCNT4 register
via the 8-bit AVR data bus. These procedures are described in section “Accessing 10-bit Registers” on
page 160.
OC4OE0 OC4OE1 OC4OE2 OC4OE3 OC4OE4 OC4OE5
OC4A (PC6) OC4A (PC7) OC4B (PB5) OC4B (PB6) OC4D (PD6) OC4D (PD7)
Bit 76543210
4
MSB LSB TCNT4
Read/Write R/W R/W R/W R/W R/W R/W R/W R/W
Initial value00000000
Bit 76543210
-----TC410TC49TC48TC4H
Read/WriteRRRRRRR/WR/W
Initial value00000000