Datasheet

11. SCRST - System Control and Reset
11.1. Resetting the AVR
During reset, all I/O Registers are set to their initial values, and the program starts execution from the
Reset Vector. If the program never enables an interrupt source, the Interrupt Vectors are not used, and
regular program code can be placed at these locations. This is also the case if the Reset Vector is in the
Application section while the Interrupt Vectors are in the Boot section or vice versa. The circuit diagram in
the next section shows the reset logic.
The I/O ports of the AVR are immediately reset to their initial state when a reset source goes active. This
does not require any clock source to be running.
After all reset sources have gone inactive, a delay counter is invoked, stretching the internal reset. This
allows the power to reach a stable level before normal operation starts. The time-out period of the delay
counter is defined by the user through the SUT and CKSEL Fuses. The different selections for the delay
period are presented in the System Clock and Clock Options chapter.
Related Links
System Clock and Clock Options on page 47
11.2. Reset Sources
The device has the following sources of reset:
• Power-on Reset. The MCU is reset when the supply voltage is less than the Power-on Reset
threshold (V
POT
).
• External Reset. The MCU is reset when a low level is present on the RESET pin for longer than the
minimum pulse length.
• Watchdog System Reset. The MCU is reset when the Watchdog Timer period expires and the
Watchdog System Reset mode is enabled.
• Brown-out Reset. The MCU is reset when the supply voltage V
CC
is less than the Brown-out Reset
threshold (V
BOT
) and the Brown-out Detector is enabled.
Atmel ATmega16M1/32M1/64M1 [DATASHEET]
Atmel-8209F-ATmega16M1/32M1/64M1_Datasheet_Complete-10/2016
66