Datasheet

7.5.2. Stack Pointer Register Low and High byte
The SPL and SPH register pair represents the 16-bit value, SP.The low byte [7:0] (suffix L) is accessible
at the original offset. The high byte [15:8] (suffix H) can be accessed at offset + 0x01. For more details on
reading and writing 16-bit registers, refer to Accessing 16-bit Registers.
When using the I/O specific commands IN and OUT, the I/O addresses 0x00 - 0x3F must be used. When
addressing I/O Registers as data space using LD and ST instructions, 0x20 must be added to these offset
addresses.
Name: SPL and SPH
Offset: 0x5D
Reset: 0x8FF
Property: When addressing I/O Registers as data space the offset address is 0x3D
Bit 15 14 13 12 11 10 9 8
SP11 SP10 SP9 SP8
Access
R R R R RW RW RW RW
Reset 0 0 0 0 1 0 0 0
Bit 7 6 5 4 3 2 1 0
SP7 SP6 SP5 SP4 SP3 SP2 SP1 SP0
Access
RW RW RW RW RW RW RW RW
Reset 1 1 1 1 1 1 1 1
Bits 0, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11 – SPn: Stack Pointer Register
SPL and SPH are combined into SP.
Atmel ATmega16M1/32M1/64M1 [DATASHEET]
Atmel-8209F-ATmega16M1/32M1/64M1_Datasheet_Complete-10/2016
27