Datasheet

Figure 10-3. On-chip Data SRAM Access Cycles
clk
WR
RD
Data
Data
Address
Address valid
T1 T2 T3
Compute Address
Read
Write
CPU
Memory Access Instruction
Next Instruction
10.4 EEPROM Data Memory
The ATmega328PB contains 1 KB of data EEPROM memory. It is organized as a separate data space, in
which single bytes can be read and written. The access between the EEPROM and the CPU is described
in the following, specifying the EEPROM Address registers, the EEPROM Data register, and the
EEPROM Control register.
See the related links for a detailed description on EEPROM Programming in SPI or Parallel Programming
mode.
Related Links
MEMPROG - Memory Programming
10.4.1 EEPROM Read/Write Access
The EEPROM access registers are accessible in the I/O space.
The write access time for the EEPROM is given in Table 10-2. A self-timing function, however, lets the
user software detect when the next byte can be written. If the user code contains instructions that write
the EEPROM, some precautions must be taken. In heavily filtered power supplies, V
CC
is likely to rise or
fall slowly on power-up/down. This causes the device for some period of time to run at a voltage lower
than specified as a minimum for the clock frequency used. Refer to Preventing EEPROM Corruption for
details on how to avoid problems in these situations.
In order to prevent unintentional EEPROM writes, a specific write procedure must be followed. Refer to
the description of the EEPROM Control register for details on this.
When the EEPROM is read, the CPU is halted for four clock cycles before the next instruction is
executed. When the EEPROM is written, the CPU is halted for two clock cycles before the next instruction
is executed.
ATmega328PB
AVR Memories
© 2018 Microchip Technology Inc.
Datasheet Complete
DS40001906C-page 35