Datasheet

ATmega164A/PA/324A/PA/644A/PA/1284/P
 2018 Microchip Technology Inc. Data Sheet Complete DS40002070A-page 304
Figure 27-3. Programming the flash waveforms
(1)
.
Note: 1. “XX” is don’t care. The letters refer to the programming description above.
27.7.5 Programming the EEPROM
The EEPROM is organized in pages, see Table 27-8 on page 299. When programming the EEPROM, the
program data is latched into a page buffer. This allows one page of data to be programmed simultaneously. The
programming algorithm for the EEPROM data memory is as follows (refer to ”Programming the Flash” on page
302 for details on Command, Address and Data loading):
1. A: Load Command “0001 0001”.
2. G: Load Address High Byte (0x00 - 0xFF).
3. B: Load Address Low Byte (0x00 - 0xFF).
4. C: Load Data (0x00 - 0xFF).
5. E: Latch data (give PAGEL a positive pulse).
K: Repeat 3 through 5 until the entire buffer is filled.
L: Program EEPROM page.
1. Set BS2, BS1 to “00”.
2. Give WR
a negative pulse. This starts programming of the EEPROM page. RDY/BSY goes low.
3. Wait until to RDY/BSY
goes high before programming the next page (See Figure 27-4 on page 305 for
signal waveforms).
RDY/BSY
WR
OE
RESET +12V
PAGEL
BS2
0x10 ADDR. LOW
ADDR. HIGH
DATA
DATA LOW DATA HIGH
ADDR. LOW DATA LOW DATA HIGH
XA1
XA0
BS1
XTAL1
XX XX
XX
ABCDEBCDEG
F
ADDR. EXT.H
H
I