Datasheet
ATmega164A/PA/324A/PA/644A/PA/1284/P
2018 Microchip Technology Inc. Data Sheet Complete DS40002070A-page 170
18.3 SS pin functionality
18.3.1 Slave mode
When the SPI is configured as a Slave, the Slave Select (SS)
pin is always input. When SS is held low, the SPI
is activated, and MISO becomes an output if configured so by the user. All other pins are inputs. When SS
is
driven high, all pins are inputs, and the SPI is passive, which means that it will not receive incoming data. Note
that the SPI logic will be reset once the SS
pin is driven high.
The SS
pin is useful for packet/byte synchronization to keep the slave bit counter synchronous with the master
clock generator. When the SS
pin is driven high, the SPI slave will immediately reset the send and receive logic,
and drop any partially received data in the Shift Register.
18.3.2 Master mode
When the SPI is configured as a Master (MSTR in SPCR is set), the user can determine the direction of the SS
pin.
If SS
is configured as an output, the pin is a general output pin which does not affect the SPI system. Typically,
the pin will be driving the SS
pin of the SPI Slave.
If SS
is configured as an input, it must be held high to ensure Master SPI operation. If the SS pin is driven low by
peripheral circuitry when the SPI is configured as a Master with the SS
pin defined as an input, the SPI system
interprets this as another master selecting the SPI as a slave and starting to send data to it. To avoid bus
contention, the SPI system takes the following actions:
1. The MSTR bit in SPCR is cleared and the SPI system becomes a Slave. As a result of the SPI becoming
a Slave, the MOSI and SCK pins become inputs.
2. The SPIF Flag in SPSR is set, and if the SPI interrupt is enabled, and the I-bit in SREG is set, the interrupt
routine will be executed.
Thus, when interrupt-driven SPI transmission is used in Master mode, and there exists a possibility that SS
is
driven low, the interrupt should always check that the MSTR bit is still set. If the MSTR bit has been cleared by
a slave select, it must be set by the user to re-enable SPI Master mode.
18.4 Data modes
There are four combinations of SCK phase and polarity with respect to serial data, which are determined by
control bits CPHA and CPOL. The SPI data transfer formats are shown in Figure 18-3 on page 171 and Figure
18-4 on page 171. Data bits are shifted out and latched in on opposite edges of the SCK signal, ensuring
sufficient time for data signals to stabilize. This is clearly seen by summarizing Table 18-3 on page 172 and
Table 18-4 on page 172, as done in Table 18-2 on page 171