Datasheet

SAM9G45 [DATASHEET]
Atmel-6438O-ATARM-SAM9G45-Datasheet_08-Dec-15
944
 For Trigger Counter at 2:
1. Close the switches on the inputs X
P
and X
M
during the Sample and Hold Time.
2. Convert Channel X
M
and store the result in TSADCC_CDR1.
3. If Channel 4 to Channel 7 are enabled, convert Channels and store result in the corresponding
TSADCC_CDRx and TSADCC_LCDR.
4. Set Trigger Counter to 3.
 For Trigger Counter at 3:
1. Close the switches on the inputs X
P
and X
M
during the Sample and Hold Time.
2. Convert Channel X
P
, subtract TSADCC_CDR1 from the result and store the subtraction result in
TSADCC_CDR0 (and also in TSADCC_LCDR if PDCEN is enabled).
3. If Channel 4 to Channel 7 are enabled, convert Channels and store result in the corresponding
TSADCC_CDRx and TSADCC_LCDR.
4. Set Trigger Counter to 4.
 For Trigger Counter at 4:
1. Close the switches on the inputs X
P
and X
M
during the Sample and Hold Time.
2. Convert Channel Y
P
and store the result in TSADCC_XPDR, subtract TSADCC_CDR1 from the result and
store the subtraction result in TSADCC_CDR1 (and also in TSADCC_LCDR if PDCEN is enabled).
3. If Channel 4 to Channel 7 are enabled, convert Channels and store result in the corresponding
TSADCC_CDRx and TSADCC_LCDR.
4. Set Trigger Counter to 5.
 For Trigger Counter at 5:
1. Close the switches on the inputs Y
P
and Y
M
during the Sample and Hold Time.
2. Convert Channel Y
M
and store the result in TSADCC_CDR3 (and store content of TSADCC_XPDR in
TSADCC_LCDR if PDCEN is enabled).
3. If Channel 4 to Channel 7 are enabled, convert Channels and store result in the corresponding
TSADCC_CDRx and TSADCC_LCDR.
4. Set Trigger Counter to 6.
 For Trigger Counter at 6:
1. Close the switches on the inputs Y
P
and Y
M
during the Sample and Hold Time.
2. Convert Channel Y
P
, subtract TSADCC_CDR3 from the result and store the subtraction result in
TSADCC_CDR2 (and also in TSADCC_LCDR if PDCEN is enabled).
3. If Channel 4 to Channel 7 are enabled, convert Channels and store result in the corresponding
TSADCC_CDRx and TSADCC_LCDR.
4. Set Trigger Counter to 7.
 For Trigger Counter at 7:
1. Close the switches on the inputs Y
P
and Y
M
during the Sample and Hold Time
2. Convert Channel X
P
, subtract TSADCC_CDR3 from the result and store the subtraction result in
TSADCC_CDR3 (and also in TSADCC_LCDR if PDCEN is enabled).
3. If Channel 4 to Channel 7 are enabled, convert Channels and store result in the corresponding
TSADCC_CDRx and TSADCC_LCDR.
4. Set Trigger Counter to 8.