Datasheet

SAM9G45 [DATASHEET]
Atmel-6438O-ATARM-SAM9G45-Datasheet_08-Dec-15
808
• DCRCE: Data CRC Error
0: No error.
1: A CRC16 error has been detected in the last data block. Cleared by reading in the HSMCI_SR.
• DTOE: Data Time-out Error
0: No error.
1: The data time-out set by DTOCYC and DTOMUL in HSMCI_DTOR has been exceeded. Cleared by reading in the
HSMCI_SR.
• CSTOE: Completion Signal Time-out Error
0: No error.
1: The completion signal time-out set by CSTOCYC and CSTOMUL in HSMCI_CSTOR has been exceeded. Cleared by
reading in the HSMCI_SR. Cleared by reading in the HSMCI_SR.
• BLKOVRE: DMA Block Overrun Error
0: No error.
1: A new block of data is received and the DMA controller has not started to move the current pending block, a block over-
run is raised. Cleared by reading in the HSMCI_SR.
• DMADONE: DMA Transfer done
0: DMA buffer transfer has not completed since the last read of HSMCI_SR.
1: DMA buffer transfer has completed.
• FIFOEMPTY: FIFO empty flag
0: FIFO contains at least one byte.
1: FIFO is empty.
• XFRDONE: Transfer Done flag
0: A transfer is in progress.
1: Command register is ready to operate and the data bus is in the idle state.
• ACKRCV: Boot Operation Acknowledge Received
0: No Boot acknowledge received since the last read of the status register.
1: A Boot acknowledge signal has been received. Cleared by reading the HSMCI_SR.
• ACKRCVE: Boot Operation Acknowledge Error
0: No error
1: Corrupted Boot Acknowledge signal received.
• OVRE: Overrun
0: No error.
1: At least one 8-bit received data has been lost (not read). Cleared when sending a new data transfer command.
When FERRCTRL in HSMCI_CFG is set to 1, OVRE becomes reset after read.