Datasheet

SAM9G45 [DATASHEET]
Atmel-6438O-ATARM-SAM9G45-Datasheet_08-Dec-15
806
35.14.12 HSMCI Status Register
Name: HSMCI_SR
Address: 0xFFF80040 (0), 0xFFFD0040 (1)
Access: Read-only
• CMDRDY: Command Ready
0: A command is in progress.
1: The last command has been sent. Cleared when writing in the HSMCI_CMDR.
• RXRDY: Receiver Ready
0: Data has not yet been received since the last read of HSMCI_RDR.
1: Data has been received since the last read of HSMCI_RDR.
• TXRDY: Transmit Ready
0: The last data written in HSMCI_TDR has not yet been transferred in the Shift Register.
1: The last data written in HSMCI_TDR has been transferred in the Shift Register.
• BLKE: Data Block Ended
This flag must be used only for Write Operations.
0: A data block transfer is not yet finished. Cleared when reading the HSMCI_SR.
1: A data block transfer has ended, including the CRC16 Status transmission.
the flag is set for each transmitted CRC Status.
Refer to the MMC or SD Specification for more details concerning the CRC Status.
• DTIP: Data Transfer in Progress
0: No data transfer in progress.
1: The current data transfer is still in progress, including CRC16 calculation. Cleared at the end of the CRC16 calculation.
• NOTBUSY: HSMCI Not Busy
This flag must be used only for Write Operations.
A block write operation uses a simple busy signalling of the write operation duration on the data (DAT0) line: during a data
transfer block, if the card does not have a free data receive buffer, the card indicates this condition by pulling down the data
line (DAT0) to LOW. The card stops pulling down the data line as soon as at least one receive buffer for the defined data
transfer block length becomes free.
31 30 29 28 27 26 25 24
UNRE OVRE ACKRCVE ACKRCV XFRDONE FIFOEMPTY DMADONE BLKOVRE
23 22 21 20 19 18 17 16
CSTOE DTOE DCRCE RTOE RENDE RCRCE RDIRE RINDE
15 14 13 12 11 10 9 8
– – CSRCV SDIOWAIT – – – SDIOIRQA
76543210
– – NOTBUSY DTIP BLKE TXRDY RXRDY CMDRDY