Datasheet

663
SAM9G45 [DATASHEET]
Atmel-6438O-ATARM-SAM9G45-Datasheet_08-Dec-15
Register (SSC_RC0R). When this start event is selected, the user can program the Receiver to start a new data
transfer either by writing a new Compare 0, or by receiving continuously until Compare 1 occurs. This selection is
done with the bit (STOP) in SSC_RCMR.
33.7.7 Data Format
The data framing format of both the transmitter and the receiver are programmable through the Transmitter Frame
Mode Register (SSC_TFMR) and the Receiver Frame Mode Register (SSC_RFMR). In either case, the user can
independently select:
 the event that starts the data transfer (START)
 the delay in number of bit periods between the start event and the first data bit (STTDLY)
 the length of the data (DATLEN)
 the number of data to be transferred for each start event (DATNB).
 the length of synchronization transferred for each start event (FSLEN)
 the bit sense: most or lowest significant bit first (MSBF)
Additionally, the transmitter can be used to transfer synchronization and select the level driven on the TD pin while
not in data transfer operation. This is done respectively by the Frame Sync Data Enable (FSDEN) and by the Data
Default Value (DATDEF) bits in SSC_TFMR.
Table 33-4. Data Frame Registers
Transmitter Receiver Field Length Comment
SSC_TFMR SSC_RFMR DATLEN Up to 32 Size of word
SSC_TFMR SSC_RFMR DATNB Up to 16 Number of words transmitted in frame
SSC_TFMR SSC_RFMR MSBF Most significant bit first
SSC_TFMR SSC_RFMR FSLEN Up to 16 Size of Synchro data register
SSC_TFMR DATDEF 0 or 1 Data default value ended
SSC_TFMR FSDEN Enable send SSC_TSHR
SSC_TCMR SSC_RCMR PERIOD Up to 512 Frame size
SSC_TCMR SSC_RCMR STTDLY Up to 255 Size of transmit start delay