Datasheet

659
SAM9G45 [DATASHEET]
Atmel-6438O-ATARM-SAM9G45-Datasheet_08-Dec-15
When both the SSC_THR and the transmit shift register are empty, the status flag TXEMPTY is set in SSC_SR.
When the Transmit Holding register is transferred in the Transmit shift register, the status flag TXRDY is set in
SSC_SR and additional data can be loaded in the holding register.
Figure 33-9. Transmitter Block Diagram
33.7.3 Receiver Operations
A received frame is triggered by a start event and can be followed by synchronization data before data
transmission.
The start event is configured setting the Receive Clock Mode Register (SSC_RCMR). See “Start” on page 660.
The frame synchronization is configured setting the Receive Frame Mode Register (SSC_RFMR). See “Frame
Sync” on page 662.
The receiver uses a shift register clocked by the receiver clock signal and the start mode selected in the
SSC_RCMR. The data is transferred from the shift register depending on the data format selected.
When the receiver shift register is full, the SSC transfers this data in the holding register, the status flag RXRDY is
set in SSC_SR and the data can be read in the receiver holding register. If another transfer occurs before read of
the RHR, the status flag OVERUN is set in SSC_SR and the receiver shift register is transferred in the RHR.
Transmit Shift Register
TD
SSC_TFMR.FSLENSSC_TFMR.DATLEN
SSC_TCMR.STTDLY
SSC_TFMR.FSDEN
SSC_TFMR.DATNB
SSC_TFMR.DATDEF
SSC_TFMR.MSBF
SSC_TCMR.STTDLY != 0
SSC_TFMR.FSDEN
10
TX Controller
SSC_TCMR.START
RF
Start
Selector
TXEN
RX Start
TXEN
RF
Start
Selector
RXEN
RC0R
TX Start
TX Start
Transmitter Clock
TX Controller counter reached STTDLY
SSC_RCMR.START
SSC_THR SSC_TSHR
SSC_CRTXEN
SSC_SRTXEN
SSC_CRTXDIS