Datasheet

589
SAM9G45 [DATASHEET]
Atmel-6438O-ATARM-SAM9G45-Datasheet_08-Dec-15
Figure 32-18. ASK Modulator Output
Figure 32-19. FSK Modulator Output
32.7.3.7 Synchronous Receiver
In synchronous mode (SYNC = 1), the receiver samples the RXD signal on each rising edge of the Baud Rate
Clock. If a low level is detected, it is considered as a start. All data bits, the parity bit and the stop bits are sampled
and the receiver waits for the next start bit. Synchronous mode operations provide a high speed transfer capability.
Configuration fields and bits are the same as in asynchronous mode.
Figure 32-20 illustrates a character reception in synchronous mode.
Figure 32-20. Synchronous Mode Character Reception
32.7.3.8 Receiver Operations
When a character reception is completed, it is transferred to the Receive Holding Register (US_RHR) and the
RXRDY bit in the Status Register (US_CSR) rises. If a character is completed while the RXRDY is set, the OVRE
(Overrun Error) bit is set. The last character is transferred into US_RHR and overwrites the previous one. The
OVRE bit is cleared by writing the Control Register (US_CR) with the RSTSTA (Reset Status) bit at 1.
Manchester
encoded
data
default polarity
unipolar output
Txd
ASK Modulator
Output
Uptstream Frequency F0
NRZ stream
10 0 1
Manchester
encoded
data
default polarity
unipolar output
Txd
FSK Modulator
Output
Uptstream Frequencies
[F0, F0+offset]
NRZ stream
10 0 1
D0 D1 D2 D3 D4 D5 D6 D7
RXD
Start
Sampling
Parity Bit
Stop Bit
Example: 8-bit, Parity Enabled 1 Stop
Baud Rate
Clock