Datasheet

403
SAM9G45 [DATASHEET]
Atmel-6438O-ATARM-SAM9G45-Datasheet_08-Dec-15
Figure 27-5. Character Reception
27.5.2.3 Receiver Ready
When a complete character is received, it is transferred to the DBGU_RHR and the RXRDY status bit in
DBGU_SR (Status Register) is set. The bit RXRDY is automatically cleared when the receive holding register
DBGU_RHR is read.
Figure 27-6. Receiver Ready
27.5.2.4 Receiver Overrun
If DBGU_RHR has not been read by the software (or the Peripheral Data Controller) since the last transfer, the
RXRDY bit is still set and a new character is received, the OVRE status bit in DBGU_SR is set. OVRE is cleared
when the software writes the control register DBGU_CR with the bit RSTSTA (Reset Status) at 1.
Figure 27-7. Receiver Overrun
27.5.2.5 Parity Error
Each time a character is received, the receiver calculates the parity of the received data bits, in accordance with
the field PAR in DBGU_MR. It then compares the result with the received parity bit. If different, the parity error bit
PARE in DBGU_SR is set at the same time the RXRDY is set. The parity bit is cleared when the control register
DBGU_CR is written with the bit RSTSTA (Reset Status) at 1. If a new character is received before the reset status
command is written, the PARE bit remains at 1.
Figure 27-8. Parity Error
D0 D1 D2 D3 D4 D5 D6 D7
DRXD
True Start Detection
Sampling
Parity Bit
Stop Bit
Example: 8-bit, parity enabled 1 stop
1 bit
period
0.5 bit
period
D0 D1 D2 D3 D4 D5 D6 D7 PS
S
D0 D1 D2 D3 D4 D5 D6 D7 P
DRXD
Read DBGU_RHR
RXRDY
D0 D1 D2 D3 D4 D5 D6 D7 PS
S
D0 D1 D2 D3 D4 D5 D6 D7 P
DRXD
RSTSTA
RXRDY
OVRE
stop
stop
stop
D0 D1 D2 D3 D4 D5 D6 D7 PS
DRXD
RSTSTA
RXRDY
PARE
Wrong Parity Bit