Datasheet
SAM9G20
DS60001516A-page 790 2017 Microchip Technology Inc.
09-Nov-15
Section 40. “Electrical Characteristics”
Added Section 40.6 “I/O Characteristics”
Section 40.9 “Core Power Supply POR Characteristics”: transferred three sections “Power Sequence Requirements”,
“Power-up Sequence” and “Power-down Sequence” to Section 4. “Power Considerations”
Added Section 40.12.2.1 “Maximum SPI Frequency”
Table 40-38, “Capacitance Load for MISO, SPCK and MOSI”: supply “1.8V” corrected to “1.8V/3.3V”
Table 40-39, “SPI Timings”: deleted instances of “VDDIOP in 1.8V range”; deleted footnote C
LOAD
is 8 pF for MISO and
6 pF for SPCK and MOSI.”
Section 40.12.3 “SSC Timings”: replaced single “SSC Timings” table with two updated tables (Table 40-41, “SSC
Timings 3.3V Domain” and Table 40-42, “SSC Timings 1.8V Domain”)
Table 40-44, “ISI Timings with Peripheral Supply 3.3V”: ISI
3
PIXCLK frequency max value “TBD” updated to “66 MHz”
Table 40-45, “ISI Timings with Peripheral Supply 1.8V”: ISI
3
PIXCLK frequency max value “TBD” updated to “55 MHz”
Section 41.1 “217-ball LFBGA Package Drawing”
Table 41-5, “Soldering Profile – 217-ball LFBGA”: removed column “BGA247 green-compliant Package”
Migrated previous section 44.1 “Marking” to Section 42. “Marking”
Section 43. “Ordering Information”
Table 43-1, “SAM9G20 Ordering Information”: replaced column “Package Type” with “Carrier Type”
Section 44. “Errata”
Section 44.1 “SAM9G20 Errata - Revision A Parts”
- added Section 44.1.3.2 “ECC: Incomplete parity status when error in ECC parity”
- added Section 44.1.3.3 “ECC: Unsupported hardware ECC on 16-bit NAND Flash”
- added Section 44.1.14.1 “PMC: PMC bad frequency after MDIV switching”
- added Section 44.1.15.1 “EBI: After reset A25 is not functionnal”
Section 44.2 “SAM9G20 Errata - Revision B Parts”
- added Section 44.2.3.2 “ECC: Incomplete parity status when error in ECC parity”
- added Section 44.2.3.3 “ECC: Unsupported hardware ECC on 16-bit NAND Flash”
- added Section 44.2.14.1 “PMC: PMC bad frequency after MDIV switching”
- added Section 44.2.15.1 “EBI: After reset A25 is not functionnal”
Doc. Rev.
6384F Comments (Continued)