Datasheet

 2017 Microchip Technology Inc. DS60001516A-page 685
SAM9G20
TXPKTRDY: Transmit Packet Ready
This flag is cleared by the USB device.
This flag is set by the USB device firmware.
Read:
0: There is no data to send.
1: The data is waiting to be sent upon reception of token IN.
Write:
0: Can be used in the procedure to cancel transmission data. (See Section 36.5.2.5 ”Transmit Data Cancellation”)
1: A new data payload has been written in the FIFO by the firmware and is ready to be sent.
This flag is used to generate a Data IN transaction (device to host). Device firmware checks that it can write a data payload in the FIFO,
checking that TXPKTRDY is cleared. Transfer to the FIFO is done by writing in the UDP_FDRx register. Once the data payload has been
transferred to the FIFO, the firmware notifies the USB device setting TXPKTRDY to one. USB bus transactions can start. TXCOMP is set
once the data payload has been received by the host.
After setting or clearing this bit, a wait time of 3 UDPCK clock cycles and 3 peripheral clock cycles is required before accessing DPR.
FORCESTALL: Force Stall (used by Control, Bulk and Isochronous Endpoints)
Read:
0: Normal state.
1: Stall state.
Write:
0: Return to normal state.
1: Send STALL to the host.
Refer to chapters 8.4.5 and 9.4.5 of the Universal Serial Bus Specification, Rev. 2.0 for more information on the STALL handshake.
Control endpoints: During the data stage and status stage, this bit indicates that the microcontroller cannot complete the request.
Bulk and interrupt endpoints: This bit notifies the host that the endpoint is halted.
The host acknowledges the STALL, device firmware is notified by the STALLSENT flag.
RX_DATA_BK1: Receive Data Bank 1 (only used by endpoints with ping-pong attributes)
This flag generates an interrupt while it is set to one.
Write (Cleared by the firmware):
0: Notifies USB device that data have been read in the FIFO’s Bank 1.
1: To leave the read value unchanged.
Read (Set by the USB peripheral):
0: No data packet has been received in the FIFO's Bank 1.
1: A data packet has been received, it has been stored in FIFO's Bank 1.
When the device firmware has polled this bit or has been interrupted by this signal, it must transfer data from the FIFO to microcontroller
memory. The number of bytes received is available in RXBYTECNT field. Bank 1 FIFO values are read through UDP_FDRx register. Once
a transfer is done, the device firmware must release Bank 1 to the USB device by clearing RX_DATA_BK1.
After setting or clearing this bit, a wait time of 3 UDPCK clock cycles and 3 peripheral clock cycles is required before accessing DPR.
DIR: Transfer Direction (only available for control endpoints)
Read/Write
0: Allows Data OUT transactions in the control data stage.
1: Enables Data IN transactions in the control data stage.
Refer to Chapter 8.5.3 of the Universal Serial Bus Specification, Rev. 2.0 for more information on the control data stage.
This bit must be set before UDP_CSRx/RXSETUP is cleared at the end of the setup stage. According to the request sent in the setup data
packet, the data stage is either a device to host (DIR = 1) or host to device (DIR = 0) data transfer. It is not necessary to check this bit to
reverse direction for the status stage.