Datasheet

SAM9263 [DATASHEET]
Atmel-6249N-ATARM-SAM9263-Datasheet_14-Mar-16
880
42.6.9 UDP Reset Endpoint Register
Name: UDP_RST_EP
Address: 0xFFF78028
Access: Read/Write
• EP0: Reset Endpoint 0
• EP1: Reset Endpoint 1
• EP2: Reset Endpoint 2
• EP3: Reset Endpoint 3
• EP4: Reset Endpoint 4
• EP5: Reset Endpoint 5
This flag is used to reset the FIFO associated with the endpoint and the bit RXBYTECOUNT in the register UDP_CSRx.It
also resets the data toggle to DATA0. It is useful after removing a HALT condition on a BULK endpoint. Refer to Chapter
5.8.5 in the USB Serial Bus Specification, Rev.2.0.
Warning: This flag must be cleared at the end of the reset. It does not clear UDP_CSRx flags.
0: No reset.
1: Forces the corresponding endpoint FIF0 pointers to 0, therefore RXBYTECNT field is read at 0 in UDP_CSRx.
Resetting the endpoint is a two-step operation:
1. Set the corresponding EPx field.
2. Clear the corresponding EPx field.
31 30 29 28 27 26 25 24
––––––––
23 22 21 20 19 18 17 16
––––––––
15 14 13 12 11 10 9 8
––––––
––
76543210
EP5 EP4 EP3 EP2 EP1 EP0