Datasheet

571
SAM9263 [DATASHEET]
Atmel-6249N-ATARM-SAM9263-Datasheet_14-Mar-16
34.6.9 Interrupt
Most bits in SSC_SR have a corresponding bit in interrupt management registers.
The SSC can be programmed to generate an interrupt when it detects an event. The interrupt is controlled by
writing SSC_IER (Interrupt Enable Register) and SSC_IDR (Interrupt Disable Register) These registers enable
and disable, respectively, the corresponding interrupt by setting and clearing the corresponding bit in SSC_IMR
(Interrupt Mask Register), which controls the generation of interrupts by asserting the SSC interrupt line connected
to the AIC.
Figure 34-16. Interrupt Block Diagram
SSC_IMR
PDC
Interrupt
Control
SSC Interrupt
Set
RXRDY
OVRUN
RXSYNC
Receiver
Transmitter
TXRDY
TXEMPTY
TXSYNC
TXBUFE
ENDTX
RXBUFF
ENDRX
Clear
SSC_IER
SSC_IDR