Datasheet

567
SAM9263 [DATASHEET]
Atmel-6249N-ATARM-SAM9263-Datasheet_14-Mar-16
Figure 34-10. Transmit Start Mode
Figure 34-11. Receive Pulse/Edge Start Modes
34.6.5 Frame Sync
The Transmitter and Receiver Frame Sync pins, TF and RF, can be programmed to generate different kinds of
frame synchronization signals. The Frame Sync Output Selection (FSOS) field in the Receive Frame Mode
Register (SSC_RFMR) and in the Transmit Frame Mode Register (SSC_TFMR) are used to select the required
waveform.
 Programmable low or high levels during data transfer are supported.
 Programmable high levels before the start of data transfers or toggling are also supported.
If a pulse waveform is selected, the Frame Sync Length (FSLEN) field in SSC_RFMR and SSC_TFMR programs
the length of the pulse, from 1 bit time up to 16 bit time.
X
TK
TF
(Input)
TD
(Output)
TD
(Output)
TD
(Output)
TD
(Output)
TD
(Output)
TD
(Output)
XBOB1
X
BO B1
BO B1
BO B1
BO B1BO B1
BO B1B1
BO
X
X
X
STTDLY
STTDLY
STTDLY
STTDLY
STTDLY
STTDLY
Start = Falling Edge on TF
Start = Rising Edge on TF
Start = Low Level on TF
Start = High Level on TF
Start = Any Edge on TF
Start = Level Change on TF
X
RK
RF
(Input)
RD
(Input)
RD
(Input)
RD
(Input)
RD
(Input)
RD
(Input)
RD
(Input)
XBOB1
X
BO B1
BO B1
BO B1
BO B1BO B1
BO B1B1
BO
X
X
X
STTDLY
STTDLY
STTDLY
STTDLY
STTDLY
STTDLY
Start = Falling Edge on RF
Start = Rising Edge on RF
Start = Low Level on RF
Start = High Level on RF
Start = Any Edge on RF
Start = Level Change on RF