Datasheet

3
SAM9263 [DATASHEET]
Atmel-6249N-ATARM-SAM9263-Datasheet_14-Mar-16
 Periodic Interval Timer, Watchdog Timer and Double Real-time Timer
 Reset Controller (RSTC)
 Based on Two Power-on Reset Cells, Reset Source Identification and Reset Output Control
 Shutdown Controller (SHDWC)
 Programmable Shutdown Pin Control and Wake-up Circuitry
 Clock Generator (CKGR)
 32.768 kHz Low-power Oscillator on Battery Backup Power Supply, Providing a Permanent Slow Clock
 3 to 20 MHz On-chip Oscillator and Two Up to 240 MHz PLLs
 Power Management Controller (PMC)
 Very Slow Clock Operating Mode, Software Programmable Power Optimization Capabilities
 Four Programmable External Clock Signals
 Advanced Interrupt Controller (AIC)
 Individually Maskable, Eight-level Priority, Vectored Interrupt Sources
 Two External Interrupt Sources and One Fast Interrupt Source, Spurious Interrupt Protected
 Debug Unit (DBGU)
 2-wire UART and Support for Debug Communication Channel, Programmable ICE Access Prevention
 Mode for General Purpose Two-wire UART Serial Communication
 Periodic Interval Timer (PIT)
 20-bit Interval Timer plus 12-bit Interval Counter
 Watchdog Timer (WDT)
 Key-protected, Programmable Only Once, Windowed 16-bit Counter Running at Slow Clock
 Two Real-time Timers (RTT)
 32-bit Free-running Backup Counter Running at Slow Clock with 16-bit Prescaler
 Five 32-bit Parallel Input/Output Controllers (PIOA, PIOB, PIOC, PIOD and PIOE)
 160 Programmable I/O Lines Multiplexed with Up to Two Peripheral I/Os
 Input Change Interrupt Capability on Each I/O Line
 Individually Programmable Open-drain, Pull-up Resistor and Synchronous Output
 One Part 2.0A and Part 2.0B-compliant CAN Controller
 16 Fully-programmable Message Object Mailboxes, 16-bit Time Stamp Counter
 Two Multimedia Card Interface (MCI)
 SDCard/SDIO and MultiMediaCard
™
Compliant
 Automatic Protocol Control and Fast Automatic Data Transfers with PDC
 Two SDCard Slots Support on each Controller
 Two Synchronous Serial Controllers (SSC)
 Independent Clock and Frame Sync Signals for Each Receiver and Transmitter
 I²S Analog Interface Support, Time Division Multiplex Support
 High-speed Continuous Data Stream Capabilities with 32-bit Data Transfer
 One AC97 Controller (AC97C)
 6-channel Single AC97 Analog Front End Interface, Slot Assigner
 Three Universal Synchronous/Asynchronous Receiver Transmitters (USART)
 Individual Baud Rate Generator, IrDA
®
Infrared Modulation/Demodulation, Manchester Encoding/Decoding
 Support for ISO7816 T0/T1 Smart Card, Hardware Handshaking, RS485 Support
 Two Master/Slave Serial Peripheral Interface (SPI)
 8- to 16-bit Programmable Data Length, Four External Peripheral Chip Selects
 One Three-channel 16-bit Timer/Counter (TC)
 Three External Clock Inputs, Two Multi-purpose I/O Pins per Channel
 Double PWM Generation, Capture/Waveform Mode, Up/Down Capability