Datasheet

221
SAM9263 [DATASHEET]
Atmel-6249N-ATARM-SAM9263-Datasheet_14-Mar-16
21.14 Static Memory Controller (SMC) User Interface
The SMC is programmed using the registers listed in Table 21-8. For each chip select, a set of 4 registers is used to pro-
gram the parameters of the external device connected on it. In Table 21-8, “CS_number” denotes the chip select number.
16 bytes (0x10) are required per chip select.
The user must complete writing the configuration by writing any one of the SMC_MODE registers.
Table 21-8. Register Mapping
Offset Register Name Access Reset
0x10 x CS_number + 0x00 SMC Setup Register SMC_SETUP Read/Write 0x01010101
0x10 x CS_number + 0x04 SMC Pulse Register SMC_PULSE Read/Write 0x01010101
0x10 x CS_number + 0x08 SMC Cycle Register SMC_CYCLE Read/Write 0x00030003
0x10 x CS_number + 0x0C SMC Mode Register SMC_MODE Read/Write 0x10001000
0xEC–0xFC Reserved – – –