Datasheet
SAM9263 [DATASHEET]
Atmel-6249N-ATARM-SAM9263-Datasheet_14-Mar-16
1082
Table 42-4 “Register Mapping”, UDP_CSR, UDP_FDR updated with indexed offsets. Footnote added to
UDP_ISR reset
Section 42.6.6 “UDP Interrupt Mask Register”, bit 12 defined as BIT12, cannot be masked.
4802
Section 42.6 “USB Device Port (UDP) User Interface”, reset value for UDP_RST_EP is 0x0000_0000
TXCV typo fixed to TXVC.
5049
Table 42-1 “USB Endpoint Description”, footnote added to Dual-Bank heading
Section 42.5.2.9 “Transmit Data Cancellation”, added to datasheet.
Section 42.6.9 “UDP Reset Endpoint Register”, added steps to clear endpoints below warning.
“TXPKTRDY: Transmit Packet Ready” bit field description in USB_CSR, updated “Write: 0 =...”
5150
UHP:
Section 41.1 “Description”, created hyperlink to “Open HCI Rev1.0 Specification”. 4361
USART
Section 33.6.3.1 “Transmitter Operations”, last paragraph updated. rfo
Section 33.6.5 “IrDA Mode”, updated with instructions to receive IrDA signals. 4912
Figure 31-1, “USART Block Diagram”, updated signal directions from to PIO. 4905
“SAM9263 Electrical Characteristics”
Table 46-2 “DC Characteristics”, V
OL
and V
OH
lines updated. 5288
Section 46.11.1 “SPI”: the Figure 46.11.1.1 on page 1046 and Figure 46-11 on page 1048 renamed. 5260
Figure 46-16, “USB Data Signal Timing Diagram”, R
EXT
= 27Ω.5610
“SAM9263 Ordering Information”
New Ordering Code: AT91SAM9263B-CU, added to Table 49-1 “SAM9263 Ordering Information”. 5560
”AT91SAM9263 Errata - Revision “A” Parts”
Section 50.1.2.2 ”TDGC Clipping Function”, added to errata.
Section 50.1.9.2 ”LCD Periodic Bad Pixels”, 16-word and 4-word offset requirements text updated.
Section 50.1.14 ”Static Memory Controller (SMC)”, ”SMC Chip Select Parameters Modification”, added
5384
5265
5642
”SAM9263 Errata - Revision “B” Parts”
Section 50.1.2.2 “TDGC Clipping Function”, added to errata.
Section 50.1.8.2 “LCD Periodic Bad Pixels”, 16-word and 4-word offset requirements text updated.
Section 50.1.14.6 “SPI: SPI Software Reset Must Be Written Twice”, added to errata.
Section 50.1.13 “Static Memory Controller (SMC)”, ”SMC Chip Select Parameters Modification”, added
5384
5265
5597
5642
Revision
6249E Comments (Continued)
Change
Request
Ref.