Datasheet

1079
SAM9263 [DATASHEET]
Atmel-6249N-ATARM-SAM9263-Datasheet_14-Mar-16
Revision
6249F Comments
Change
Request
Ref.
Section 5.1 ”Power Supplies”, VDDCORE and VDDBU updated.
Section 5.2, “Power Sequence Requirements removed from datasheet.
5791/5793
USART:
Section 33.5.1 “I/O Lines”, reference to modem mode removed.
Section 33.3 “Application Block Diagram”, updated and modem removed
5743
Revision
6249E Comments
Change
Request
Ref.
Overview:
New Ordering Code: AT91SAM9263B-CU added to Table 49-1 “SAM9263 Ordering Information”.5560
Section 8.1.2.1 ”BMS = 1, Boot on Embedded ROM”, changes to list under “Bootloader on a non-volatile
memory”.
5425
Section 5.2 ”Power Sequence Requirements”, section added to datasheet. 5643
Section 10.4.3 ”EBI1”, System Resource Multiplexing, Ethernet 10/100 MAC limitation on EBI1 updated. 5713
Section 10.5.8 ”Multimedia Card Interface”, protocol specification compatibilities updated. 5282
Table 3-1, ”Signal Description List”, Image Sensor Interface, ISI_MCK is provided by PCK3.
Table 10-6, ”Multiplexing on PIO Controller E”, ISI_MCK removed from PE11 line of the table.
5329
New!!! Address Offsets added to all register tables in User Interface sections of the datasheet. rfo
AIC:
“AIC Spurious Interrupt Vector Register” on page 393 fixed typo in bitfield.
Section 28.6.3 “Interrupt Sources”, Interrupt Source 1 OR-wiring description updated.
Section 28.7.5 “Protect Mode”, “writing PROT enables Debug Control Protect Mode in AIC_DCR register,
updated.
4749:
5191
5193
Boot Program:
Section 12.1 “Overview”, 3rd and 4th paragraphs updated.
Section 12.6 “NAND Flash Boot”, 1st and 2nd paragraphs removed, 3rd paragraph updated.
5244
Section 12.6.1 “Supported NAND Flash Devices”, must be connected on EBI0. 5266
Section 12.3 “Device Initialization”, additional supported crystals added in Table 12-1.5280
CAN:
Section 36.6.4.6 “Error Interrupt Handler” on page 642, section added to datasheet.
4736