Datasheet

SAM9263 [DATASHEET]
Atmel-6249N-ATARM-SAM9263-Datasheet_14-Mar-16
1074
28-Jan-16
Section 44. “Two D Graphics Controller (TDGC)” (cont’d)
Removed reset value from register description sections (reset values are provided in Table 44-2 “TDGC Register
Mapping”)
Section 45. “Image Sensor Interface (ISI)”
Table 45-9 “Register Mapping”:
- ISI_SR: access “Read” corrected to “Read-only”
- ISI_IER and ISI_IDR: access “Read-write” corrected to “Write-only”; removed reset value
- ISI_IMR: access “Read/-write” corrected to “Read-only”
Removed reset value from register description sections (reset values are provided in Table 45-9 “Register Mapping”)
Section 45.4.3 “ISI Status Register”: access “Read” corrected to “Read-only”
Section 45.4.4 “Interrupt Enable Register” and Section 45.4.5 “ISI Interrupt Disable Register”: access “Read-write”
corrected to “Write-only”
Section 45.4.6 “ISI Interrupt Mask Register”: access “Read-write” corrected to “Read-only”
Section 46. “SAM9263 Electrical Characteristics”
Table 46-1 “Absolute Maximum Ratings*”: removed “Operating Temperature” line
Section 46.4 “Core Power Supply POR Characteristics”: transferred power-up and power-down sequence content to
Section 4.2 “Power Sequence Requirements”
Table 46-11 “Main Oscillator Characteristics”: deleted footnote “C
S
is the shunt capacitance.”
Updated Section 46.9.1 “SMC Timing Conditions”
Updated Section 46.9.4 “SDRAMC Signals”
Table 46-29 “SDRAMC Signals”: deleted footnote “The derating factor is not to be applied to t
CLMCK
or t
CHMCK
.”
Table 46-31 “SDRAMC Signals”: deleted footnote “The derating factor is not to be applied to t
CLMCK
or t
CHMCK
.”
Section 46.11.1.1 “Maximum SPI Frequency”: updated content under ”Master Read Mode”
Added Section 46.11.1.2 “Timing Conditions”
Section 46.11.1.3 “Timing Extraction”: added content relative to MISO and MOSI sampling; inserted Figure 46-9 “MISO
Capture in Master Mode”
Table 46-36 “SPI Timings”: deleted footnote “Cload is 8 pF for MISO and 6 pF for SPCK and MOSI.”
Section 46.11.4 “UDP and UHP Switching Characteristics”: renamed figure and tables
Section 47. “SAM9263 Mechanical Characteristics”
Section 47.1 “Package Drawing AT91SAM9263B-CU”: added note “Device AT91SAM9263B-CU is no longer
available.”
Transferred section “Marking” to Section 48. “Marking”
Section 49. “SAM9263 Ordering Information”
Table 49-1 “SAM9263 Ordering Information”:
- removed ordering code AT91SAM9263B-CU
- column “Package Type” replaced by “Carrier Type”
Table 51-2. Revision History - SAM9263 Datasheet Revision 6249M (Continued)
Date Comments