Datasheet

735
SAM9261 [DATASHEET]
Atmel-6062O-ATARM-SAM9261-Datasheet_21-Jun-16
TC: Added information on compare register B and waveform generation in Section 33.6.12
“External Event/Trigger Conditions” on page 527. Added Note
(1)
to Register Bit Description
“EEVT: External Event Selection” on page 535 in “TC Channel Mode Register: Waveform
Mode” on page 534 to further clarify.
Added Figure 33-2, “Clock Chaining Selection,” on page 517 to demonstrate clock chaining.
2704
3342
UHP: Corrected signal name in block diagram Figure 35-1 on page 582 to UHPCK.
Updated schematic Figure 35-4, “Board Schematic to Interface UHP Device Controller,” on
page 585 and added text on termination serial resistor in Section 35.6 “Typical Connection” on
page 585.
2924
3365
UDP: All sections and information on wake-up/remote wake-up updated.
Section 36.7.10 “UDP Endpoint Control and Status Register” on page 614, changes to Write
and Read values in FORCESTALL bit .
Section 36.7.2 “UDP Global State Register” on page 604 activity of ESR and RMWUPE bits
updated.
Note added to TXVDIS bit description in Section 36.7.12 “UDP Transceiver Control Register”
on page 620 describing USB pullup effect on USB reset.
3048
3055
In Table 38-2, “DC Characteristics,” on page 633, updated static current value for V
VDDCORE
=
1.2V. In Table 38-3, “Power Consumption for Different Modes,” on page 678, updated Quasi
static current value for V
VDDCORE
= 1.2V.
3806
In Table 38-3, “Power Consumption for Different Modes,” on page 678, added Note
(1)
on
SRAM access in Idle Mode.
3903
Updated Table 38-8, “32 kHz Oscillator Characteristics,” on page 680 and Table 38-10, “Main
Oscillator Characteristics,” on page 681 with new information on capacitances.
4065
Errata: Updated Section 42.1.3.3 “Boot ROM: Temperature Range” on page 701. Added
Section 42.1.7.1 “NTRST: Device does not boot correctly due to powerup sequencing issue”
on page 703. Removed
SSC: Transmitter Limitations in Slave Mode errata.
4094
3881
Doc. Rev.
6062F
Date
01-Dec-06 Comments
Change
Request
Reference
Updated VDDOSC, VDDPLL and VDDIOM ranges in”Features”, Table 3-1, “Signal
Description by Peripheral,” on page 5, Section 5.2 ”Power Consumption” on page 11 and
Table 38-2, “DC Characteristics,” on page 635.
3660,
3695, 3690
Added ROM to Figure 8-1, “AT91SAM9261 Memory Mapping,” on page 16. 3660
All values changed in Table 38-1, “Absolute Maximum Ratings*,” on page 635. 3697
Updated values in Table 38-5, “Processor Clock Waveform Parameters,” on page 638. 3687
Doc. Rev.
6062G 22-Feb-07 Comments (Continued)
Change
Request
Ref