Datasheet
733
SAM9261 [DATASHEET]
Atmel-6062O-ATARM-SAM9261-Datasheet_21-Jun-16
Doc. Rev.
6062H
Date
13-Nov-07 Comments
Change
Request
Ref.
Overview:
Table 9-4, “Multiplexing on PIO Controller C,” on page 33,
PCO - PC7 power supplies are VDDIOP not VDDIOM.
5042
Section 7.1.2 “Boot Strategies”, removed sentence pertaining to “remap”
Section 7.1.2.2 “BMS = 0, Boot on External Memory”, “NANDFlash Boot“ added to list.
5027
rfo
Section 4.1 “Power Supplies”, startup voltage slope requirements for VDDCORE and VDDBU
added.
4965
Table 9-3, “Multiplexing on PIO Controller B,” on page 32, Note added to “PB3” comments 4844
Figure 8-3, “Power Management Controller Block Diagram,” on page 26, in the master
memory controller representation, the divider has been updated.
4835
Table 3-1 on page 9,
PCO - PC7, PC8 - PC11, PC14 - PC15 power supplies are VDDIOP not VDDIOM.
4241
Boot Program
Section 12.1 “Description”, updated.
Section 12.7 “NAND Flash Boot”, added to Boot Program.
Figure 12-3 ”LDR Opcode”, updated.
Section 12.11 “Hardware and Software Constraints”, updated
rfo
rfo
4452
rfo
BUS Matrix:
Section 18.5.4 “EBI Chip Select Assignment Register” EBI_DBPUCD: ....bits pulled up to the
VDDIOM power supply.
4467
PMC
Section 24. ”Clock Generator” removed reference to RC Oscillator
Section 24.4.2 ”Divider and Phase Lock Loop Programming”, last sentence added.
Section 24.7 “Programming Sequence”, 2nd sentence in step 3 and step 4 added.
5065
4839
RSTC
Figure 14-1 ”Reset Controller Block Diagram” There is one block diagram.
Section 14.3.2 ”NRST Manager”, the brownout manager figure has been removed
4565
SHDW
Section 18.2 ”Block Diagram”, updated
Table 18-2, “Register Mapping,” updated
4733
Electrical/Mechanical Characteristics
Section 38.2 “DC Characteristics”, removed reference to junction temperature
Section 39. “Mechanical Characteristics”, “Thermal Considerations” removed
4729
Table 38-8 “32 kHz Oscillator Characteristics” V
DDOSC
= 1.2V 4243
Section 38.5.2 “32 kHz Crystal Characteristics”, added to datasheet 4836
Section 38.4.2 “Master Clock Characteristics”, added to datasheet 4302
Table 38-2, “DC Characteristics,” Typical values assigned. 5003