Datasheet

SAM9261 [DATASHEET]
Atmel-6062O-ATARM-SAM9261-Datasheet_21-Jun-16
446
character is being transmitted. If a break is requested while a character is being shifted out, the character is first
completed before the TXD line is held low.
Once STTBRK command is requested further STTBRK commands are ignored until the end of the break is
completed.
The break condition is removed by writing US_CR with the STPBRK bit at 1. If the STPBRK is requested before
the end of the minimum break duration (one character, including start, data, parity and stop bits), the transmitter
ensures that the break condition completes.
The transmitter considers the break as though it is a character, i.e. the STTBRK and STPBRK commands are
taken into account only if the TXRDY bit in US_CSR is at 1 and the start of the break condition clears the TXRDY
and TXEMPTY bits as if a character is processed.
Writing US_CR with the both STTBRK and STPBRK bits at 1 can lead to an unpredictable result. All STPBRK
commands requested without a previous STTBRK command are ignored. A byte written into the Transmit Holding
Register while a break is pending, but not started, is ignored.
After the break condition, the transmitter returns the TXD line to 1 for a minimum of 12 bit times. Thus, the
transmitter ensures that the remote receiver detects correctly the end of break and the start of the next character.
If the timeguard is programmed with a value higher than 12, the TXD line is held high for the timeguard period.
After holding the TXD line for this period, the transmitter resumes normal operations.
Figure 31-16 illustrates the effect of both the Start Break (STTBRK) and Stop Break (STPBRK) commands on the
TXD line.
Figure 31-16. Break Transmission
31.6.3.11 Receive Break
The receiver detects a break condition when all data, parity and stop bits are low. This corresponds to detecting a
framing error with data at 0x00, but FRAME remains low.
When the low stop bit is detected, the receiver asserts the RXBRK bit in US_CSR. This bit may be cleared by
writing the Control Register (US_CR) with the bit RSTSTA at 1.
An end of receive break is detected by a high level for at least 2/16 of a bit period in asynchronous operating mode
or one sample at high level in synchronous operating mode. The end of break detection also asserts the RXBRK
bit.
D0 D1 D2 D3 D4 D5 D6 D7
TXD
Start
Bit
Parity
Bit
Stop
Bit
Baud Rate
Clock
Write
US_CR
TXRDY
TXEMPTY
STPBRK = 1
STTBRK = 1
Break Transmission End of Break