Datasheet

439
SAM9261 [DATASHEET]
Atmel-6062O-ATARM-SAM9261-Datasheet_21-Jun-16
Figure 31-7. Transmitter Status
31.6.3.2 Asynchronous Receiver
If the USART is programmed in asynchronous operating mode (SYNC = 0), the receiver oversamples the RXD
input line. The oversampling is either 16 or 8 times the Baud Rate clock, depending on the OVER bit in the Mode
Register (US_MR).
The receiver samples the RXD line. If the line is sampled during one half of a bit time at 0, a start bit is detected
and data, parity and stop bits are successively sampled on the bit rate clock.
If the oversampling is 16, (OVER at 0), a start is detected at the eighth sample at 0. Then, data bits, parity bit and
stop bit are sampled on each 16 sampling clock cycle. If the oversampling is 8 (OVER at 1), a start bit is detected
at the fourth sample at 0. Then, data bits, parity bit and stop bit are sampled on each 8 sampling clock cycle.
The number of data bits, first bit sent and parity mode are selected by the same fields and bits as the transmitter,
i.e. respectively CHRL, MODE9, MSBF and PAR. For the synchronization mechanism only, the number of stop
bits has no effect on the receiver as it considers only one stop bit, regardless of the field NBSTOP, so that
resynchronization between the receiver and the transmitter can occur. Moreover, as soon as the stop bit is
sampled, the receiver starts looking for a new start bit so that resynchronization can also be accomplished when
the transmitter is operating with one stop bit.
Figure 31-8 and Figure 31-9 illustrate start detection and character reception when USART operates in
asynchronous mode.
Figure 31-8. Asynchronous Start Detection
D0 D1 D2 D3 D4 D5 D6 D7
TXD
Start
Bit
Parity
Bit
Stop
Bit
Baud Rate
Clock
Start
Bit
Write
US_THR
D0 D1 D2 D3 D4 D5 D6 D7
Parity
Bit
Stop
Bit
TXRDY
TXEMPTY
Sampling
Clock (x16)
RXD
Start
Detection
Sampling
Baud Rate
Clock
RXD
Start
Rejection
Sampling
12345678
123456701234
123456789 10111213141516
D0
Sampling